512562
34
Zoom out
Zoom in
Previous page
1/42
Next page
34
TRACKER 5100/5100i/5500/5500i Installation and Operation Manual
NAVMAN
Power/data cable for display unit
Wire the cable as shown on the next page.
Note:
The unit requires 12 V DC power. This power
supply must be protected with a fuse or circuit
breaker of between 2 and 3 A. If it does not
have this, fit a 2 A fuse in the power supply line.
To enable auto power (see section 2-1),
connect the yellow Power/data cable wire to
the positive power supply as shown.
To disable auto power, leave the wire
disconnected; make sure it can not touch any
other conductor.
If the external beepers and lights require more
than 200 mA DC total, fit a relay.
For information on how to connect NavBus, refer
to the NavBus Installation and Operation manual.
Setup and test
1 Remove the dust covers from the connectors.
2 Plug the eight way connectors into their
sockets on the back of the display unit:
Match the colour on the end of the
connector to the colour of the nut on the
socket.
Hold the plug against the socket and rotate
the plug until it slides into the socket.
Lock the plug in place by pushing the
locking collar towards the socket and
turning it a quarter turn clockwise.
Nothing will be damaged if a cable is plugged
into the wrong socket by mistake.
3 If the unit has an external GPS antenna:
Plug the gold connector into its socket on
the back of the display unit.
Hand tighten the locking collar clockwise -
do not overtighten.
4 If the display unit is bracket mounted:
i Hold the display unit in place on the
mounting bracket shaft, with the rubber
washer clamped between the bracket and
the display unit.
ii Adjust the tilt and rotation of the display unit
for best viewing and hand tighten the knob.
5 Remove the dust cover. Turn the TRACKER on
(see section 2-1).
6 Insert any required C-MAP™ chart card (see
section 1-2).
7 When the TRACKER is turned on for the first
time, the TRACKER displays an installation
menu of setup data:
i Select the language to use.
ii Change the setup data if necessary:
Select the data item to change.
Use the cursor keys to change the data.
Press ENT.
iii When the setup data is correct, press
ESC.
These installation options can be changed
later, through the setup menu (see section 13).
8 At the satellite display, check that it picks up
GPS satellites. Wait for the GPS receiver to
start up and the fix type to change from
‘Acquiring’ to ‘GPS fix’. This should take less
than two minutes (see section 7).
9 If the TRACKER is to send NMEA data to an
autopilot, set this up (see section 13-8).
10 If the TRACKER is part of a NavBus system,
set the backlight group. Otherwise turn NavBus
off (see section 13-8).
11 Go on a test run to check that the navigation
equipment works correctly, particularly when a
radio transmitter or radar is used.
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Navman Tracker 5500i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Navman Tracker 5500i in the language / languages: English as an attachment in your email.

The manual is 0,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Navman Tracker 5500i

Navman Tracker 5500i User Manual - German - 43 pages

Navman Tracker 5500i User Manual - Dutch - 41 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info