512562

Navman Tracker 5500i Manual

29
Zoom out
Zoom in
Previous page
1/42
Next page
29
TRACKER 5100/5100i/5500/5500i Installation and Operation Manual
NAVMAN
13-5 Track setup
Tracking records and displays the boat’s course on
the chart (see section 3-5).
Record
Off: The TRACKER stops recording a track.
1 to 5 (select a track number): The TRACKER
starts recording the boat’s course into the
selected track.
Display
Off: No track is shown on the chart.
1 to 5 (select a track number): The selected
track is shown on the chart.
Plotting Interval
The options are Distance or Time.
Distance
Select the distance plotting interval: 0.01, 0.05, 0.1,
0.5, 1.0, 2.0, 5.0 or 10.0 distance units.
Time
Select the time plotting interval: 1, 5, 10 or 30 seconds
or 1 minute.
Memory used
The percentage of memory used in the track being
recorded.
Tip: Use the user card display to check the number
of points recorded in each track (see section 11).
Delete track
1 Select the track number to delete (1 to 5).
2 Select Yes to confirm.
The data in the selected track is deleted.
13-6 Alarms setup
Fuel Cal
Without calibration the error in fuel measurements
can be up to ± 10%. Calibration can reduce the error
substantially. For twin engine installations calibration
of each transducer is required.
Calibrating the fuel transducer requires accurate
measurement of the fuel used. This is easiest with a
small portable tank. It should be noted that due to air
pockets, it is very difficult to fill underfloor tanks to
the same level twice. At least 15 litres (4 US gallons)
should be used to ensure an accurate calibration.
(The more fuel used, the more accurate the
calibration will be.) Each transducer in a twin engine
installation must be calibrated separately. This may
be done at the same time with two portable tanks, or
at different times using one tank at a time.
The procedure is:
1 Select Clear Used to set Used to zero.
2 Connect the measurement tank(s) to the
engine(s) via the fuel transducer(s).
3 Run the engine(s) at normal cruising speed until
at least 15 litres (4 US gallons) is indicated
(30 litres [8 US gallons] for twin engines).
For alarm operation, see section 2-5. To turn off an
alarm which is sounding, press ESC.
Arrival radius alarm
When the arrival radius alarm is enabled, an alarm
will sound:
a When the boat is going to a point and the boat
comes within the arrival radius of the
destination.
b Or when the boat is navigating a route and the
boat comes within the arrival radius of a
waypoint in the route.
To enable the alarm, enter an arrival radius (up
to 9.99 distance units).
To disable the alarm, set the arrival radius to Off (0).
Anchor alarm
When the anchor alarm is enabled, an alarm will
sound when the boat moves by more than the anchor
alarm distance.
4 Check the actual amount of fuel used per
engine. The easiest way to do this is to refill
the tank(s) to the original level(s) and record
the value(s) shown on the fuel dispenser.
5 Select Fuel Cal. The amount of fuel that the
TRACKER has measured is displayed.
Change the number to the actual fuel amount
used. (Repeat for the other engine in a twin
engine installation).
Flow Filter
Normally engines do not draw fuel from the tank at a
steady rate. To give a stable fuel flow reading, the
TRACKER calculates the flow values by taking several
measurements and averaging them. The flow filter
sets the period over which the fuel flow is averaged,
and can be set from 1 to 180 seconds or Off.
Set the flow filter to the lowest value which give a
stable flow. Usually a value of 10 to 15 seconds will
give a satisfactory result for carburettor engines. Fuel
injected engines may require a larger value.
This setting affects the Flow rate and Economy
displays. It does not affect the fuel used measurement.
… 29 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Navman Tracker 5500i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Navman Tracker 5500i in the language / languages: English as an attachment in your email.

The manual is 0,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Navman Tracker 5500i

Navman Tracker 5500i User Manual - German - 43 pages

Navman Tracker 5500i User Manual - Dutch - 41 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info