470006
12
Zoom out
Zoom in
Previous page
1/37
Next page
Press MENU one or more times until the Setup
menu is displayed, then select Alarms:
Trigger settings can be defined to suit the boat
and individual preferences as follows:
Alarms can be set (enabled) to automatically
detect certain conditions, such as the water
being too shallow. Alarms that are enabled are
shown as black icons in the Alarm status box on
the sonar displays.
When an enabled alarm is triggered, the
beeper sounds, an alarm message is displayed
and the alarm status icon flashes.
Press ENT or ESC to acknowledge the alarm,
stop the beeper and close the alarm window.
This does not disable the alarm.
Alarms automatically re-enable
The Too shallow, Too Deep and Low
battery alarms automatically re-enable
when the value moves outside the alarm
trigger setting.
The Temperature alarm automatically
re-enables when the temperature is more
Symbol Alarm
Name
Beeper
Cycle
Alarm condition is met
when the:
Too
shallow
1
/
5
sec Depth is less than
the alarm trigger value
Too
deep
1
/
2
sec Depth is greater than
the alarm trigger value
Fish 1 short
beep
Echo matches the
profile of a fish
Temp.
1
/
2
sec Temperature equals
the alarm trigger value
Temp.
rate
1
/
2
sec Rate of change of
temperature equals the
alarm trigger value
Low
battery
1
/
2
sec Battery voltage is
less than the alarm
trigger value
Low
fuel *
1
/
2
sec Fuel remaining equals the
alarm trigger value
*Only 4432
3-6 Setup > Units
3-5 Setup > Alarms
Press MENU one or more times until the Setup
menu is displayed, then select Units:
Baro
InHg (Inches of mercury)
• Mb (Millibars) - sometimes called kPa
Speed
Select from:
kn (knots)
mph (miles per hour)
kph (kilometres per hour)
Wind
• True
• Apparent
Depth
Select from:
ft (feet)
m (metres)
fa (fathoms)
Pressure
• kPa
• psi
than 0.45°F (0.25°C) above or below the alarm
trigger setting.
The Temperature rate alarm
automatically re-enables when the rate of
temperature change falls below the trigger
setting by more than 0.2°F (0.1°C) per minute.
Flashing light and/or external beeper
If a secondary alarm indicator is required,
a flashing light and/or external beeper can
be installed. These can be positioned
anywhere suitable on the boat. See section
6-5 Wiring options.
The default units
are shown in this
example.
Distance
Select from:
nm (nautical miles)
mi (miles)
km (kilometres)
FISH 4432/4433 Installation and Operation Manual 14
NAVMAN
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Navman FISH 4432 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Navman FISH 4432 in the language / languages: English as an attachment in your email.

The manual is 0,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Navman FISH 4432

Navman FISH 4432 Usermanual and installation guide - Dutch - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info