470014
14
Zoom out
Zoom in
Previous page
1/32
Next page
14
NAVMAN
FISH 4200 Installation and Operation Manual
Select MAIN MENU - DATA to display the DATA
screen:
A graph displays the surface water temperature for
the last 40 minutes and is updated every 30 seconds.
The current water temperature is displayed above
the graph and is updated every second.
3-7 DATA screen
The temperature can be displayed in °F
(Fahrenheit) or °C (Celsius). Use the SETUP -
UNITS - TEMPERATURE menu to select the
desired temperature units (see section 4-2).
Alarms that indicate a specific temperature, or rate
of change of temperature, may be enabled (see
section 4-1).
Log. One of two distance logs can be displayed:
Trip Log or Total Log. Both logs are retained in the
FISH 4200 memory when the unit is switched off.
Use the SETUP - LOG menu to select the Trip Log
or Total Log (see section 4-6). The Trip Log must
be reset manually (e.g. to record total mileage
during a season, or the distance travelled on this
trip). Note that the units displayed on each Log will
correspond with the Speed.
Speed can be displayed in knots (KN), miles per
hour (MPH), or kilometres per hour (KPH). Use the
SETUP - UNITS - SPEED menu to select the
desired speed units (see section 4-2).
Battery
voltage
Depth
Speed
3-8 FUEL screen
To use the fuel display, the optional fuel kit must be
installed and the fuel data set-up (see section 4-8).
Select MAIN MENU - FUEL to display the FUEL
screen:
If FUEL does not
appear on the MAIN
MENU screen, enable
it using the SETUP -
INSTALL option (see
section 4-8).
USED shows the total
fuel used since it was
reset to 0 by the CLEAR
USED command (see
section 4-7).
REMAINING shows the amount of fuel remaining in the
fuel tanks.
FLOW shows the fuel consumption per hour. For twin
engine installations the fuel flow for each engine is
shown separately. This is useful for checking that
both engines are under the same load.
ECONOMY is the distance travelled per unit of fuel
used. The NAVMAN fishfinder calculates this from
the boat speed and fuel used. The bigger the
number, the better the fuel economy. Adjust the
throttle and trim to achieve the best fuel economy.
SPEED is the current speed of the boat.
The water depth and the enabled alarms are shown
at the base of the screen.
Warnings:
Fuel economy can change drastically
depending on boat loading and sea
conditions. Always carry adequate fuel for
the journey plus a sufficient reserve.
Each time fuel is added or removed use
the fuel setup menu (see section 4-7) to
record the fuel or else fuel remaining and
the low fuel alarm will be meaningless!
Temperature
Temperature
Graph
Log
Engine hours
Enabled
alarms
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Navman FISH 4200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Navman FISH 4200 in the language / languages: English as an attachment in your email.

The manual is 0,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info