512555
7
Zoom out
Zoom in
Previous page
1/77
Next page
7
FUEL 3100 / DIESEL 3200 Installation and Operation Manual
NAVMAN
2 Operation
The unit has four keys, ESC, ENT, and .
In this manual:
Press means push the key for less than one
second.
Hold means hold the key down until the
display changes.
In general:
Press to change what is displayed in the
upper display.
In a setup menu, press or hold to
increase the setting.
Press to change what is displayed in the
lower display.
Petrol flow sensor (FUEL 3100): The petrol
flow sensor is fitted in the fuel line between the
fuel tank and the engine. A small turbine inside
the fuel flow sensor measures the rate of the
fuel flow into the engine. This information is
relayed through the fuel flow sensor cable and
shown electronically on the display unit.
Diesel flow sensor (DIESEL 3200): A diesel
sensor is a positive displacement flowmeter,
with one moving internal part, made of low
friction, fuel proof plastic. There are no fine
pointed shafts and jewelled bearings to get
worn or hammered by diesel pulsing.
Each engine is fitted with two fuel flow
sensors, to measure fuel supply and return.The
system calculates the engine consumption,
compensating for pulsing from diaphragm
lift pumps, different fuel temperatures in
the supply and return lines and the flow
characteristics of the sensors.
Clean the display unit and any plastic sensor
with a damp cloth or mild detergent. Avoid
abrasive cleaners, petrol or other solvents.
1-2 How the flow sensors work
1-3 Cleaning and maintenance
1-4 Calibration
Put the protective cover over the display when
it is not being used.
FUEL 3100: It is essential to calibrate the fuel
flow sensors after installation and again after
the first 100 engine hours to allow moving
parts to wear in (see section 3-4).
DIESEL 3200: The sensors are factory
calibrated and are highly accurate. They can be
calibrated but this should not be necessary.
2-2 The Keys
2-1 Turning on and off
The display unit does not have its own power
switch, but if possible should be wired so that it
turns on when the engine ignition is turned on
to allow the engine hours counter to function
properly. (See section 4 -5).
Turn the unit on and off with the boat’s ignition
switch. The display unit does not have its own
power switch. When the unit it is turned off,
any settings you have made are retained.
If SIM flashes at the bottom left corner of the
display, the unit is in simulation mode (see
section 2-9).
In a setup menu, press or hold to decrease
the setting.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Navman Diesel 3200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Navman Diesel 3200 in the language / languages: English as an attachment in your email.

The manual is 2,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Navman Diesel 3200

Navman Diesel 3200 User Manual - German, Dutch, French - 77 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info