637884
4
Zoom out
Zoom in
Previous page
1/56
Next page
Correct Disposal Of This Product
This marking indicates that this pr
oduct should not be disposed with other household wastes throughout the
EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle
it responsibly to promote the sustainable reuse of material resources. To return your used device, please use
the return and collecon systems or contact the retailer where the product was purchased. They can take
this product for environmental safe recycling.
Gas Cylinder
Use only gas cylinders, which meet naonal and r
egional codes. The minimum cylinder size for butane units
is 13kg, and for propane units is 6kg. Ensure that the cylinder can provide enough fuel to operate the appli-
ance. If in doubt, check with your local gas supplier.
Use cauon when handling the cylinder valve.
Never connect a cylinder, which does not meet local codes.
All cylinders must be placed outside the enclosure (under the right side shelf) on level ground.
connected to the appliance may be stored in the enclo-
must not be stored in the enclosure, or in close proximity of
to extreme heat or direct sunlight.
WARNI
NG!
Ensure that the hose is routed t
o maintain proper clearance to the underside of the unit.
Hoses that contact high temperature surfaces may melt and leak, causing a re.
Cylinder Connecon: Ensure that the gas regulator hose is kink free. Remove the cap or plug from the cylin-
der fuel valve. Tighten regulator to cylinder valve. Leak test all joints prior to using the barbecue. A leak test
must be performed annually, and each me a cylinder is hooked up, or if a part of the gas system is replaced.
WARNI
NG!
Do not route hose underneath drip pan.
Do not route hose between space in boom shelf and back panel.
Do not route hose over top of back panel.
Ensure all connecons are ghtened using two wrenches. Do not use Teon tape or pipe dope on any
hose connecon.
Ensure the hose does not contact any high temperature surfaces, or it may melt and leak causing a re.
Do not use enclosure to store excess hose, as there is a greater chance of the hose contacng a hot sur-
face, it may melt and leak causing a re.
4
www.napoleongrills.com
Gas Hose
If the hose and regulator ar
e not included by the manufacturer, then only hoses and regulators which
meet naonal and regional codes are to be used.
Ensure that the hose does not come into contact with grease, other hot drippings, or any hot surfaces on
the appliance.
Check hose regularly. In the case of rips, melng or wear, replace hose before using the appliance.
The recommended hose length is 0.5m. The hose must not be longer than 1.5m.
Ensure that the hose is twist and kink free when installed.
Replace the hose before expiry date printed on the hose.
EN
Only cylinders
sure, or close to the appliance. Spare cylinders
an operang unit. Cylinders must not be exposed
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Napoleon Triumph 495SB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Napoleon Triumph 495SB in the language / languages: English, German, French as an attachment in your email.

The manual is 16,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info