637888
9
Zoom out
Zoom in
Previous page
1/56
Next page
9
www.napoleongrills.com
EN
Ligh
ts: T
o r
e
mo
v
e
the
le
ns fr
om the light housing, insert a at screwdriver p between the lens and the
hous
ing and r
ock it g
en
tly
. Do not t
ouch the halog
en bulb. The o
il fr
om y
our ng
erps will reduce the
life of the bulb. To clean the lens, rst soak it in hot soapy water, then clean with a rag and non abrasive
cleaner. To reinstall the lens, simply snap it back into the housing.
Tube Burner: The burners are made from heav
y wall 304 stainless steel, but extreme heat and a corrosive
envi
ronment can cause surface corrosion to occur. This c
an be removed with a brass wire brush.
CAUTION!
Beware of Spiders.
Spiders and insects are aracted t
o the smell of propane and natural gas. The burner is equipped with an
insect screen on the air shuer, which reduces the likelihood of insects building nests inside the burner
but does not enrely eliminate the problem. A nest or web can cause the burner to burn with a so
yellow or orange ame or cause a re (ashback) at the air shuer beneath the control panel. To clean the
inside of the burner, it must be removed from the gas grill: Remove the screw that aaches the burner to
the back wall. Slide the burner back and upwards to remove. Cleaning: Use a exible venturi tube brush
to clean the inside of the burner. Shake any loose debris from the burner through the gas inlet. Check the
burner ports and valve orices for blockages. Burner ports can close over me due to cooking debris and
corrosion, use an opened paperclip or the supplied port maintenance bit to clean them. Drill out blocked
ports using this drill bit in a small cordless drill. The ports are easier to clean if the burner is removed from
the grill, but it can also be done with the burner installed. Do not ex the drill bit when drilling the ports,
as this will cause the drill bit to break. This drill is for burner ports only, not for the brass orices (jets)
which regulate the ow into the burner. Take care not to enlarge the holes. Ensure the insect screen is
clean, ght, and free of any lint or other debris.
Reinstallaon: Reverse the procedure to reinstall the burner. Check that the valve enters the burner when
installing.
WARNING!
Accumulated grease is a re hazard.
Drip Pan: Clean the drip pan frequently (e
very 4 – 5 uses or as oen as required) to avoid grease buildup.
Grease and excess drippings pass through to the drip pan, located beneath the gas grill and accumulate in
the disposable grease tray below the drip pan. To access the disposable grease tray or to clean the drip
pan, slide the drip pan free of the grill. Never line the drip pan with aluminum foil, sand or any other mate-
rial as this could prevent the grease from owing properly. The pan should be scraped out with a puy
knife or scraper. Replace the disposable grease tray every 2 – 4 weeks, depending on gas grill usage. For
supplies, see your Napoleon Gas Grill dealer.
Cleaning The Outer Grill Surface: Do not use abrasive cleaners or steel wool on any painted, porcelain or
stainless steel parts of your Napoleon Grill. Doing so will scratch the nish. Exterior grill surfaces should be
cleaned with warm soapy water while the metal is sll warm to the touch. To clean stainless surfaces, use
a stainless steel or a non-abrasive cleaner. Always wipe in the direcon of the grain. Over me, stainless
steel parts discolor when heated, usually to a golden or brown hue. This discoloraon is normal and does
not aect the performance of the grill. Porcelain enamel components must be handled with addional
care. The baked-on enamel nish is glass-like, and will chip if struck. Touch-up enamel is available from
your Napoleon Grill dealer.
WARNING!
Hose: Check for abrasions, melng, cuts, and cracks in the hose. If any of these
condions exist, do not use the g
as grill. Have the part replaced by your Napoleon Gas Grill dealer or
qualied gas installer.
WARNING!
When reinstalling the burner aer cleaning it is very
important tha
t the valve/orice enters the burner tube before lighng your
gas grill. If the valve is not inside the burner tube a re or explosion could
occur.
Aluminum Casngs: Clean casngs periodically with warm soapy water
. Aluminum will not rust, but high
temperatures and weathering can cause oxidaon to occur on aluminum surfaces. This appears as white
spots on the casngs. To renish these areas, clean rst and sand lightly with ne sandpaper. Wipe the
surface to
remove any residue and paint with high te
mperature barbecue paint. Protect surrounding
areas from over-spray. Follow the manufacture’s direcons for curing.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Napoleon Triumph 325 SB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Napoleon Triumph 325 SB in the language / languages: English, German, French as an attachment in your email.

The manual is 12,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info