Manual Napoleon Clearion Elite (page 12 of 120) (English, German, Dutch, French)

798822

Zoom out

Zoom in

1/120

W415-3030 / A / 10.29.21

installation

2.6 installing the appliance

A. Frame an opening (see “framing” section for details).

B. Make hardwire connections on the left of the intended front side.

C. Remove the front trims of the appliance (see “front trim removal / installation” section).

D. Remove the front glass from the appliance (see “front glass removal / installation” section).

E. Remove the 2 MDF support ends from the appliance by removing the screws. Discard both MDF boards.

Use 4 new screws (supplied) on each side to cover MDF board screw holes (Fig. 2-1).

6 1/8” (164mm)

Center

of stud

Fig. 2-2

It is recommended to have the walls of the appliance enclosure be ﬁ nished (i.e. drywall) to avoid exposed

insulation or vapour barrier coming in contact with the appliance. This will ensure clearance to combustibles is

maintained.

note:

Wall anchors are not required when screwing into the wall stud.

B x 4

A x 4

It is recommended to use a magnetic screwdriver bit during installation to prevent the screws from falling into the

appliance.

B x 8

Fig. 2-1

F. Mark the centre of the wall depth on the vertical stud and install the mounting brackets by aligning the

edge of the bracket with the centre marking. Measure 6 1/8” (164mm) from the bottom of the bracket to

the bottom of the opening (Fig. 2-2).

FRONT

Hard-wiring

location

Installation uses 2 mounting brackets in opposite corners. Looking at the stud from the centre of the opening,

the brackets will extend out to the right (Fig. 2-2).

note:

6 1/8” (164mm)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Napoleon Clearion Elite in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 14.8 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Napoleon Clearion Elite Manual

Product: