637929
14
Zoom out
Zoom in
Previous page
1/60
Next page
www.napoleongrills.com
14
EN
Troubleshoong
Problem Possible Causes Soluon
Low heat / Low ame
when valve turned to
high.
For propane - improper lighng
procedure.
For natural gas - undersized
supply line.
For both gases - improper
preheang.
Ensure lighng procedure is followed carefully. All
gas grill valves must be in the o posion when the
tank valve is turned on. Turn tank on slowly to allow
pressure to equalize. See lighng instrucons.
Pipe must be sized according to installaon code.
Preheat grill with both main burners on high for 10
to 15 minutes.
Excessive are-ups/
uneven heat.
Sear plates installed incorrectly.
Improper preheang.
Excessive grease and ash build on
sear plates and in drip pan.
Ensure sear plates are installed with the holes
towards the front and the slots on the boom. See
assembly instrucons.
Preheat grill with both main burners on high for 10
to 15 minutes.
Clean sear plates and drip pan regularly. Do not
line pan with aluminum foil. Refer to cleaning
instrucons.
Burners burn with
yellow ame,
accompanied by the
smell of gas.
Possible spider web or other
debris, or improper air shuer
adjustment.
Thoroughly clean burner by removing. See general
maintenance instrucons. Open air shuer slightly
according to combuson air adjustment instrucons.
(This must be done by a qualied gas installer.)
Flames li away from
burner, accompanied
by the smell of gas, and
possibly dicules in
lighng.
Improper air shuer adjustment. Close air shuer slightly according to combuson air
adjustment instrucons. (This must be done by a
qualied gas installer.)
Rear and Side burners
will not light with the
igniter, but will light
with a match.
Dead baery / or installed
incorrectly.
Loose electrode wire or switch
terminal wires.
Liing ames on burner.
Replace with premium heavy duty baery.
Check that electrode wire is rmly pushed onto the
terminal on the back of the igniter. Check that the
lead wires from the module to the ignion switch (if
equipped) are rmly pushed onto their respecve
terminals.
Close air shuer slightly - see previous problem.
Main burner will not
light with the igniter,
but will light with a
match.
Jet-re outlet is dirty or clogged. Clean jet-re outlet with a so bristle brush.
Humming regulator. Normal occurrence on hot days. This is not a defect. It is caused by internal vibraons
in the regulator and does not aect the performance
or safety of the gas grill. Humming regulators will not
be replaced.
Burners will not cross
light each other.
Dirty or corroded cross light
brackets.
Clean or replace as required.
“Paint” appears to be
peeling inside lid or
hood.
Grease build-up on inside
surfaces.
This is not a defect. The nish on the lid and hood is
porcelain, and will not peel. The peeling is caused by
hardened grease, which dries into paint-like shards,
that ake o. Regular cleaning will prevent this. See
cleaning instrucons.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Napoleon BILEX 730 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Napoleon BILEX 730 in the language / languages: English as an attachment in your email.

The manual is 7,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info