Manual Naim CD555 (page 7 of 18) (English)

651535

Zoom out

Zoom in

1/18

CD555

6. CD555 In Use

6.1 Disc Loading

To open the transport door press the player door button or

the handset open key. To load a disc place it on the platter

followed by the magnetic puck. Do not use a puck from any

other Naim CD player.

If the player is stopped the door will open automatically

when a hand is moved towards the proximity sensor located

in the player front panel display window.

To close the door press the player door button or the

handset open key. The door will also close if the player play

button or handset play key are pressed.

Note: If the door hits an obstruction the door indicator

will ash and the door will stop moving. Remove the

obstruction before attempting to open or close the door

again.

Note: If the door is left open for ve minutes it will close

automatically to prevent inadvertent damage or dust

build-up within the player.

Note: If an HDCD® encoded compact disc is loaded the

CD555 will automatically recognise and decode it. The

display will read HDCD for a few seconds after play is

pressed.

6.2 Player Maintenance

It is important for reliable operation of the CD555 to ensure

that the surfaces of the transport platter and the underside

of the puck are free of dust or debris which can prevent the

disc from sitting properly and cause it to slip.

To clean the transport platter, take a piece of Blu-Tack and

lightly apply it to the top surface of the hub, picking up any

material attached to it. Brush the plastic outer edge lightly

with your nger or a soft brush to ensure that it is dust and

particle free. Similarly, clean the puck with Blu-Tack, to

remove debris from its underside.

Do not, under any circumstances, use any solvents or uids

for the cleaning process.

6.3 Player Door Reset and Calibration

If at any time the player door fails to open or close correctly,

or the top panel door button ashes, the door may need re-

setting and calibrating. The procedures are as follows.

Note: It may only be necessary to carry out the Position

Calibration procedure.

6.3.1 Door Position Calibration

Switch the player o. Hold down the top panel door button

and switch the player on. The player display should read - - .

Switch the player o and, after a short while, back on again.

If the door button ashes this indicates that the Door Reset

and Motion Calibration procedures are necessary. Carry out

the following two procedures.

6.3.2 Door Reset

Note: Door Reset will also reset DIN/Phono Socket

selection, Display settings, RC5/RS232 settings and

Control Mode setting (see Section 16.2).

Switch the player o. Hold down the top panel stop button

and switch the player on. Switch the player o and carry out

the Door Motion Calibration procedure.

6.3.3 Door Motion Calibration

With the door fully closed press and hold the top panel door

and play buttons and switch the player on.

The door will continually open and close and the level of

open/close gain adjustment will be displayed. Allow the

player to run until the values displayed for open and close

have settled to consistent values. The door should now open

and close consistently. Switch the player o and, after a

short while, back on again. The door should now operate

correctly.

HDCD

, High Definition Compatible Digital

and Pacific Microsonics™ are either registered trademarks or trademarks of Pacific Microsonics, Inc. in the United States and/or other countries.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Naim CD555 in the language / languages: English as an attachment in your email.

The manual is 2,56 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Naim CD555

Naim CD555 User Manual - German - 18 pages

Naim CD555 User Manual - French - 18 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Naim CD555 Manual

Product: