PAGE 13INTRODUCTION
Identification of Controls
Open the battery cover.
Insert batteries (AAA size).
Close the cover.
1
2
3
Make sure to martch the + and - on the batteries
to the marks inside the battery compartment.
Notes on the remote control
Direct the remote control at the remote sensor of
the DVD player.
Do not drop or give the remote control a shock.
Do not leave the remote control near extremely
hot or humid place.
Do not spill water or put anything wet on the
remote control.
Do not open the remote control.
Notes
Improper use of batteries may cause battery
leakage and corrosion.
To operate the remote control correctly, follow the
instructions below.
Do not insert the batteries into the remote control
in the wrong direction.
Do not charge, heat, open, or short-circuit the
batteries. Do not throw the batteries into fire.
Do not leave dead or exhausted batteries in the
remote control.
Do not use different types of batteries together, or
mix old and new batteries.
If you do not use the remote control for a long
period of time, remove the batteries to avoid
possible damage from battery corrosion.
If the remote control does not function correctly or
if the operating range becomes reduced, replace
all batteries with new ones.
If battery leakage occurs, wipe the battery liquid
from the battery compartment, then insert new
batteries.
The batteries should last about one year with
normal use.
Insert the batteries into the remote control so you can
use it to operate the DVD player.
This section shows you how to use the remote
control.
Point the remote control at the remote sensor and
press the buttons
Distance : About 23 ft (7 m) from the front of the
remote sensor.
Angle : About 30˚ in each direction of the front of
the remote sensor.
Do not expose the remote sensor of the DVD
player to a strong light source such as direct
sunlight or illumination. If you do so, you may not
be able to operate the DVD player with the
remote control.
Preparing the Remote Control Operating with the Remote Control
