745048
7
Zoom out
Zoom in
Previous page
1/22
Next page
1 SE IN (SINGLE-ENDED)
Use single-ended analog audio input for sources (CD Player, tuner,
preamplier, processor or other applicable devices) that are not
equipped with BALANCED analog audio output.
2 PHONO
Input for either a Moving Coil or Moving Magnet phono cartridge.
Connect the twin RCA lead from your turntable to this input.
3 PHONO GROUND CONNECTOR
Turntables normally include a single wire earth lead. Use the M12
phono ground connector to connect this lead.
Unscrew the terminal to expose the hole that will accept the lead.
After insertion, tighten the terminal to secure the lead.
4 COAXIAL IN 1-2, OPTICAL IN 1-2
Connect to the corresponding optical or coaxial digital output of
sources such as CD or BD/DVD players, digital cable box, digital
tuners and other applicable devices.
5 COMPUTER
Asynchronous USB 24 bit/192 kHz input assures lowest jitter for best
musical performance.
Using Type A to Type B cable connector (not supplied), interface
computer audio to this asynchronous Type B USB input to directly
stream 24/192 PCM content from your PC or MAC.
Ensure that the Sound or Audio device setting of your computer is
set to “NAD USB Audio.
MINIMUM PC SYSTEM REQUIREMENT
Microsoft Windows XP Service Pack 2 or higher, Microsoft Windows 7
FOR MAC USERS
Minimum Mac OS X Snow Leopard (version 10.6) and later versions
NOTE
Download and install to your PC the NAD USB Audio driver from
the Manuals/Downloads tab of the NAD web address -http://
nadelectronics.com/products/masters-series/M12-Digital-Preamp-DAC
6 DIGITAL USB BACK
Connect a USB mass storage device to this input. Typical USB
mass storage devices compatible with M12 include portable ash
memory devices and external hard drives (FAT32 formatted).
Refer also to the item about LISTENING TO USB DEVICE at the
OTHER FEATURES section of the OPERATION page.
7 ANALOG PRE-OUT/SUB
These output terminals have dual function. They are used either as
ANALOG PRE-OUT or SUBWOOFER terminals.
Always turn OFF the M12 and associated external devices before
connecting or disconnecting anything to the ANALOG PRE-OUT/
SUB sockets.
ANALOG PRE-OUT
The ANALOG PRE-OUT sockets can be used to drive an additional
amplier. Use a dual RCA cable to connect ANALOG PRE-OUT to the
corresponding analog audio input of compatible devices such as
ampliers, receivers or other applicable devices.
ANALOG PRE-OUT will be aected by the M12’s volume control
settings. Rotate the VOLUME control to adjust the output level of
the ANALOG PRE-OUT sockets.
SUBWOOFER
Use a dual RCA cable to connect SUB to the low level input of a
powered subwoofer.
Low frequency information up to 200Hz is sent to the connected
subwoofer via SUBW1 or SUBW2.
8 DIGITAL OUT (COAXIAL, OPTICAL)
Connect DIGITAL OUT (optical or coaxial) to the corresponding
digital audio input of compatible devices such as receivers,
computer soundcard or other digital processors.
IDENTIFICATION OF CONTROLS
REAR PANEL
© NAD M12
SE IN
GND
L
BAL
R
R L
R L
PHONO
1 2 3 4 5 6 7 8 9 10 11 12
13 14 15 16 17 18
ATTENTION!
Please make sure that the M12 is powered o or unplugged from the mains power source before making any connections. It is also advisable to power
down or unplug all associated components while making or breaking any signal or AC power connections.
7
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NAD M12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NAD M12 in the language / languages: English as an attachment in your email.

The manual is 3,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NAD M12

NAD M12 User Manual - German - 22 pages

NAD M12 User Manual - Dutch - 22 pages

NAD M12 User Manual - French - 22 pages

NAD M12 User Manual - Italian - 22 pages

NAD M12 User Manual - Swedish - 22 pages

NAD M12 Quick start guide - Spanish - 22 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info