493504
22
Zoom out
Zoom in
Previous page
1/26
Next page
SPEAKERS ON/OFF ‑ HEADPHONE
There are times when you may want the speakers to be silent but with
Preamp Output remaining active. An example would be driving an external
Headphone Amplier or Powered Speaker.
The HEADPHONE feature is premised upon having the SPEAKERS turned
ON or OFF. The speakers can be turned ON or OFF via the following
method.
Alternately press and hold AVR 4’s MUTE button to enable or disable the
speakers (“Speakers ON” or “Speakers OFF” is shown at the front panel
display).
SPEAKERS ON
SPEAKERS terminal is enabled or turned ON.
SPEAKERS OFF
SPEAKERS terminal is disabled or turned OFF.
“Headphone ON” is shown on the lower portion of the current Source.
With SPEAKERS turned OFF, one can hear the current source as
streamed through PRE-OUT/SUBW or COAXIAL OUT/OPTICAL OUT
terminals via the amplier, receiver or other applicable media they are
connected to.
IMPORTANT NOTES
Only digital sources are available at COAXIAL OUT/OPTICAL OUT.
All other sources including the digital sources can be heard through
SPEAKERS terminal and also streamed via PRE-OUT/SUBW terminals.
Subwoofer cannot be enabled if the speakers are set to “Speakers OFF”.
USB MODE
The C 390DD is equipped with three USB input terminals – USB Front, USB
Back and Computer. Using either “USB Front” or “USB Back, the C 390DD
can play back MP3/WMA/FLAC les stored in external USB (Universal Serial
Bus) mass storage devices. Use “Computer” to interface computer audio
and directly stream 24/96 PCM content from your PC or MAC.
DIGITAL USB FRONT/DIGITAL USB BACK USB TYPE A
Supports playback of MP3, WMA and FLAC les
MP3/WMA: 48 kHz
FLAC: 24 bit/48 kHz
FAT12/16 root directory up to 256 les (short names)
FAT12/16/32 up to 65535 les (short names) per directory
FAT le system limited to 2TB
File and directory names limited to 64 characters
Up to 16 maximum level of directories
Supports USB version 1.1
COMPUTER USB TYPE B
Supports 24 bit/96 kHz PCM content from PC or MAC
NOTE
Typical USB mass storage devices compatible with C 390DD include
portable ash memory devices and external hard drives (FAT32
formatted).
IMPORTANT NOTE ABOUT CONTROL BUTTONS
The control buttons mentioned in this manual may refer to either front
panel or remote control buttons. Check out the buttons shown with
respect to the actual front panel or remote control. There are front panel
and remote control buttons that may not exactly look alike but have
the same function – example: front panel’s [d/f/a/s] and remote
control’s [D/F/A/S]; front panel’s [a SOURCE s] and remote control’s
[SOURCE5/6].
LISTENING TO USB DEVICE
1 Toggle [a SOURCE s] button to select “USB Front” or “USB Back source
mode. If no USB mass storage device is connected to USB Front or
USB Back input, “Please Insert Device” will be displayed in the VFD. If
there are no applicable MP3/WMA/FLAC les available in the USB mass
storage device, the VFD will show “No les found”.
2 Plug-in the USB mass storage device to the USB input – MP3, WMA or
FLAC les or folders will be displayed in the VFD.
3 Use [d/f/a/s] to select through the les or folder. Press [s], [S] or
[ENTER] to start playback of particular le.
4 Toggle AVR 4’s [DISP] button to show information about the current le.
USB PLAYBACK CONTROLS
Using the AVR 4 remote control, the following playback control buttons are
applicable for USB playback. Set DEVICE SELECTOR to MP for USB playback
control.
ENTER/S : Select USB le and at the same time start playback.
A : Return to previous display.
4 : Resume playback from pause mode.
j : Pause current playback.
9 : Skip back to the preceding song.
0 : Skip forward to the next song.
RPT: Repeat track (le), folder, all or repeat o.
DISP: Toggle to display applicable information about the le currently
playing.
IMPORTANT NOTICE
Do not disconnect the USB mass storage device during playback as it
may damage the C 390DD.
LISTENING TO A COMPUTER
Use Type A to Type B cable connector to directly stream 24/96 PCM
content from your PC or MAC to the C 390DD. Ensure that the Sound or
Audio device setting of your computer is set to “NAD USB Audio”.
MINIMUM PC SYSTEM REQUIREMENT
Microsoft Windows XP Service Pack 2 or higher, Microsoft Windows 7
FOR MAC USERS
Minimum Mac OS X Snow Leopard (version 10.6) and later versions.
RENAMING A SOURCE INPUT
A particular source input can be renamed according to your preference.
You can use up to 20 characters in renaming a source input. Below is the
procedure on how to rename a source input.
Example: Rename “Digital Coaxial 1” to “BD Player.
1 Toggle [a SOURCE s] button until “Digital Coaxial 1”.
2 Then, press and hold front panel’s [a SOURCE] button until “Digital
Coaxial 1” is shown in the lower section of the VFD and with “D” ashing.
Note that “Digital Coaxial 1” is also shown at upper section of the VFD.
3 Within 5 seconds, toggle the [d/f] buttons to select the rst character
(“B” from the alphabetical list). The ranges of characters available are
A-Z, a-z, _ (space) and 0-9.
4 Press [s] to select the character and at the same time move on to the
next character. Repeat steps 3 and 4 for each character in sequence.
5 Complete the renaming process by pressing the [ENTER] button again
to save the new source input name.
NOTE
The renaming process will be automatically terminated if no button
is pressed within 5 seconds. Any renamed characters at the time of
termination will not be saved.
OPERATION
OTHER FEATURES
22
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NAD C 390 DD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NAD C 390 DD in the language / languages: English as an attachment in your email.

The manual is 2,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NAD C 390 DD

NAD C 390 DD User Manual - German - 24 pages

NAD C 390 DD User Manual - Dutch - 24 pages

NAD C 390 DD User Manual - French - 24 pages

NAD C 390 DD User Manual - Italian - 24 pages

NAD C 390 DD User Manual - Swedish - 24 pages

NAD C 390 DD User Manual - Spanish - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info