610971
10
Zoom out
Zoom in
Previous page
1/12
Next page
10
KICKSPACE
®
500, 600, 600-12V & 800
12.0 Troubleshooting
Once installed this fan convector becomes an integral part of a
complete heating system that includes boiler, pump, other
emitters such as radiators and fan convectors, and a number of
heating controls, dependent on system complexity. An apparent
problem with this unit may be the result of system controls being
incorrectly set and can be solved easily without calling out your
installer or MYSON Service. Before calling your installer or
MYSON Service, please carry out the checks listed below.
Note: If you call out MYSON Service to a fault detailed below,
or to repair a fault caused by incorrect use, a call out charge will
be made.
Common Installation Faults
For optimum performance, this unit must be correctly sized to
match the heat loss requirements of the space it is required to
heat, and the heating system must be correctly designed to
provide adequate flow of hot water to the unit (see Section 2).
If the recommendations in Section 2 are not followed,
problems may arise as detailed below.
Central heating
Mode - No Fan
Central Heating Mode
- poor heating
performance and/or
unit cycles on
low limit thermostat
Possible Causes
Unit switched off
Room thermostat not calling for heat
Unit not switched on at fused spur
Fuse blown at fused spur
Unit isolating valves shut
Water temperature reaching
fan convector below 32°C
Remote control switched off (if fitted)
Problem Remedy
Low water temperature to unit Turn up boiler thermostat
Poor water flow Vent air from heating system
Turn on
Turn up room thermostat
Switch on at spur
Replace fuse
Open valves
Check boiler - Programmer ON
Boiler ON and set to high with
central heating pump running
Note: Operation of fan can be checked by
switching to summer setting
Switch to heating mode
Poor heating
performance
(unit may cycle on
low limit thermostat)
Possible Causes
Boiler thermostat set too low
Lack of flow to fan convector
Pump set on low setting
Isolating valves not fully open
System incorrectly balanced with unit starved of hot water flow
Pipe sizing to unit too small
Problem
Poor heating
performance
Unit incorrectly sized for heat loss of room
If the fan convector is still faulty after checking the above, call your installer or MYSON Service.
KICKSPACE 500, 600, 600-12V & 800 INSTALLATION & MAINTENANCE MANUAL
01.01.2013 ISSUE 6
26690 Kickspace Manual for web_Layout 1 24/09/2013 10:08 Page 11
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Myson KICKSPACE 600-12V at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Myson KICKSPACE 600-12V in the language / languages: English as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Myson KICKSPACE 600-12V

Myson KICKSPACE 600-12V Usermanual and installation guide - Dutch - 6 pages

Myson KICKSPACE 600-12V Usermanual and installation guide - Dutch - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info