655831
5
Zoom out
Zoom in
Previous page
1/15
Next page
EN - 3 EN - 4
NEW ONE S.A.S
10, Rue de la Mission, 25480 Ecole Valentin, France
MORE INFORMATION
WARNING!
The ventilation should not be impeded by covering the ventilation openings with items such as newspapers, table-cloths,
curtains, etc.
• No naked ame sources, such as lighted candles, should be placed on the apparatus.
• The use of apparatus in moderate climates.
• The apparatus should not be exposed to dripping or splashing.
• Ensure a minimum distance of 5cm around the apparatus for sufcient ventilation.
• Do not place objects lled with liquids, such as vases, on the apparatus.
• The marking plate is located on the back of unit.
Under the inuence of electrical fast transient or/and electrostatic phenomenon, the product may malfunction and require
user to power reset.
CAUTION: To reduce the risk of electric shock, do not remove the cover (or back). There are no user
serviceable parts inside the unit. Refer all servicing to qualify personnel.
The lightening ash with arrowhead symbol within the triangle is a warning sign alerting the user of dangerous
voltage” inside the unit.
If at any time in the future you should need to dispose of this product please note that Waste electrical products
should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice.(Waste Electrical and Electronic Equipment Directive)
The exclamation point within the triangle is a warning sign alerting the user of important instructions accompanying
the product.
RECORDING FROM PHONO, AUX IN TO USB
HOW TO REPLACE THE TURNTABLE STYLUS (NEEDLE)
TIPS FOR BETTER TURNTABLE PERFORMANCE
SPECIFICATIONS
Removing the USB device
Please be sure to stop playback and turn the unit OFF before removing the USB device to avoid damage the USB and
system.
1. Connect the USB device to the USB port (Make sure the USB device have enough space to save the encoding).
2. Select one of your favorite mode (PHONO or AUX IN) and start your mode playback.
3. Press RECORD to start recording, LED indicator lit RED, Press PLAY/PAUSE once to interrupt the recording, LED
indicator ashing in RED, press PLAY/PAUSE again to resume recording.
4. Press RECORD to stop recoding, LED indicator goes off.
5. To listen the recording, set the PHONO/AUX-USB mode selector to USB position, the recording will playback
automatically.
6. Press BACK or NEXT to select your track.
7. Press STOP to stop playback.
USING HEADPHONES / EARPHONES
Maximum output voltage ≤ 150Mv
HEADPHONE VOLUME WARNING
Connect earphones with the volume set low and increase it if required. Prolonged listening through some earphones at
high volume settings can result in hearing damage. When headphones/earphones are connected, no sound will be emitted
from the unit’s speaker.
Caution: Avoid listening to sound at levels which may be harmful to your ears.
Removing the Stylus(needle) from the Cartridge
1. Raise the Tone Arm.
To remove the old stylus needle, Place a screwdriver
at the tip of the stylus and push downward as shown in
direction “A”.
2. Remove the stylus by pulling the stylus forward and
pushing downward.
Installing the Stylus
1. Hold the tip of the stylus and insert the stylus by
pressing as shown in direction “B”.
2. Push the stylus upward as in direction "C" until the
stylus locks into the tip position.
1. When opening or closing the turntable cover, handle it gently, gripping it either at the centre or at each side.
2. Do not touch the needle tip with your ngers; avoid bumping the needle against the turntable platter or record edge.
3. Frequently clean the needle tip-use a soft brush in a “back-to-front’ motion only.
4. If you must use a needle cleaning uid, use very sparingly.
5. Gently wipe the dust cover and turntable housing with a soft cloth. Use only a small amount of mild detergent to clean
the turntable and dust cover.
6. Never apply harsh chemicals or solvents to any part of the turntable system.
To prevent possible hearing damage, do not listen at high volume levels for long periods.
USING THE RCA LINE OUT JACK
Connect one end of audio cable (cable not included) to the LINE OUT jack on the rear of unit and other end of cable connect
to the RCA IN jack or AUX in jack of your other audio drive equipment.
1. Turn on your audio drive equipment.
2. Select one of your favorite mode(PHONO, USB, AUX IN) and start your mode playback.
GENERAL
Power: 100-240V 50/60Hz, 0.5A
Output: DC 9V 1000mA
Output Power: 2 X 1W RMS
HXT-3750 IB MUSE 001 REV1.indd 5 2016/4/28 10:03:18
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Muse MT-101 BR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Muse MT-101 BR in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 3,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info