Manual Multiplex ROYALevo12 (page 13 of 57) (English)

30266

Zoom out

Zoom in

1/57

ROYAL evo

Page 68

Tip:

Threading the wires is easier if you slightly bend the

wire-ends and hold the stick in one of the corners.

3. Clip the wires in the holders designed for them on

the stick unit. Check that the wires have sufficient

freedom when the stick is deflected; they must not

be under tension at any point, and should not snag

anywhere.

4. Connect the bare wire ends to the appropriate

green screw-terminals on the main circuit board;

you will need a small slot-head screwdriver for this.

Remove the battery and push the wires in from the

battery-facing side of the terminals. It does not

matter which way round the wires are connected.

Fig. 1

Fig. 2

7.4.11. Installing the optional switches “P” and “K”

If you need extra functions 2-position switches can be

installed in the installation wells “P” and “K”. To fit them

the corresponding corner unit must be removed from

the transmitter:

1. Locate the TORX screwdriver (in a clip below the

aerial guide sleeve, close to the screen) and undo

the four TORX screws holding the appropriate stick

unit (Fig. 1).

2. Check that the switches are at the centre position,

then carefully withdraw the corner unit from the

transmitter. Remove the rotary knob (push-fit) from

the 3-D digi-adjustor when you withdraw the unit

(Fig. 2).

3. Use a small screwdriver to push out the blind cover

from the inside.

4. Fit the switch and secure it with the retaining nut

supplied (Fig. 3). Note the correct orientation: the

yellow wire should face the battery.

5. Re-install the corner unit, fit the retaining screws

and push the rotary knob back onto the 3-D digi-

adjustor (note correct position: internal index

shoulder). Connect the plug attached to the new

switch directly to the micro-connector on the cor-

ner unit (Fig. 4).

Fig. 1

Fig. 2

Fig. 3

Fig. 4

8. The transmitter battery

The ROYALevo is powered by a high-quality ready-made

battery pack consisting of 6 NiMH cells (Nickel-Metal-

Hydride) of the AA size. NiMH cells offer a much higher

energy density (capacity : weight) than NiCd (Nickel-

Cadmium) cells, and therefore provide longer operating

times for the same weight. They do require slightly dif-

ferent handling and greater care, especially when

charging.

8.1. Battery management in the ROYALevo

8.1.1. This is what we have already

Battery voltage display

Most transmitters show the battery voltage in graphic

or numeric form.

Battery alarm

An audible alarm indicates the voltage falling below the

minimum level. In many transmitters the minimum level

can be set by the user.

Both features are available in the ROYALevo of course.

(Battery alarm è 13.1.3.)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Multiplex ROYALevo12 in the language / languages: English as an attachment in your email.

The manual is 2,45 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Multiplex ROYALevo12

Multiplex ROYALevo12 User Manual - German - 58 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Multiplex ROYALevo12 Manual

Product: