Manual Multiplex Razor (page 18 of 56) (English, German, French, Italian, Spanish)

561614

Zoom out

Zoom in

1/56

Operating Instructions

MULTIcont BL-15 brushless controller

MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten • www.multiplex-rc.de Page 3/4

Anleitung MULTIcont BL-15 # 82 5959 (12-04-26/BRAN) • Errors and omissions excepted. •



MULTIPLEX

Select direction of rotation

(triple beep, continuously repeated)

3.1

For reverse rotation

→ stick to full-throttle

position

OR:

For standard rotation*

→ stick to motor OFF

position

⇒ Confirmation signal

emitted

3.2

Stick to centre position

Select motor cut-off type

(quadruple beep, continuously repeated)

4.1

For motor cut

(hard stop)

→ stick to full-

throttle position

OR:

For power

reduction *

→ stick to motor

OFF position

⇒ Confirmation signal emitted

LiPo batteries:

Motor off at 3.0 V / cell

NiXX batteries:

Motor off at 6.0 V!

LiPo batteries:

Motor speed is reduced at 3.2 V /

cell  throttle stick to motor OFF

position  open throttle  motor off

completely at 2.9 V / cell

NiXX batteries:

Motor speed is reduced at 6.0 V 

throttle stick to motor OFF position

 open throttle  motor off

completely at 5.8 V / cell

4.2

Stick to centre

position

Select motor start-up behaviour

(five-times beep, continuously repeated)

5.1

For soft-start *

→ stick to full-throttle

position

OR:

For standard start-up

→ stick to motor OFF

position

⇒ Confirmation signal

emitted

Motor start-up time in

helicopter mode:

approx. 7.0 sec

in fixed-wing mode:

approx. 1.3 sec

Motor start-up time in

helicopter mode:

approx. 2.0 sec

in fixed-wing mode:

approx. 0.2 sec

5.2

Stick to centre position

Select automatic timing

(six-times beep, continuously repeated)

6.1

For automatic timing ON*

→ stick in full-throttle

position

OR:

For automatic timing OFF

→ stick to motor OFF

position

⇒ Confirmation signal

emitted

6.2

Stick to centre position

Select manual timing

→ only if automatic timing was previously set to OFF

(seven-times beep, continuously repeated)

7.1

For “hard” timing

(22 - 30 degrees)

→ stick to full-throttle

position

OR:

For “soft” timing (7 degrees)

→ stick to motor OFF

position

⇒ Confirmation signal

emitted

Recommended for

in-runners

Recommended for

out-runners

7.2

Stick to centre position

Select pulse frequency

(eight-times beep, continuously repeated)

8.1

For 8 kHz pulse frequency

→ stick to full-throttle

position

OR:

For 16 kHz* pulse

frequency

→ stick to motor OFF

position

⇒ Confirmation signal

emitted

8.2

Stick to centre position

Select model type

(nine-times beep, continuously repeated)

9.1

For helicopters (Governor

Mode)

→ stick to full-throttle

position

OR:

For fixed-wing models*

→ stick to motor OFF

position

⇒ Confirmation signal

emitted

Governor mode = constant

rotational speed maintained

In Governor mode the

Brake is automatically

switched OFF, even if you

previously selected Brake

10.

Quitting programming mode

10.1

Stick to centre position

⇒ Rising tone sequence

10.2

Stick to motor OFF position

⇒ Rising tone sequence

sounds twice: the controller

is ready for use, the altered

parameters have been

stored

* Default setting / as supplied

7. BEC = (BATTERY ELIMINATOR CIRCUIT)

MULTIcont BL-15 speed controllers are equipped with a BEC

system: the receiver and servos are fed power from the flight

battery via the regulator; no separate receiver battery is required.

Never connect a separate receiver battery!

Please note that the MULTIcont BL-15 speed controller’s BEC

power supply can only deliver a limited current to the receiving

system in the model:

The actual current drawn by a servo varies according to its

performance, the frequency of commands and – in particular –

the freedom of movement of the control surface linkages (!). This

means that it is essential to measure the current drain of the

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Multiplex Razor in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 1,86 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Multiplex Razor Manual

Product: