30232
22
Zoom out
Zoom in
Previous page
1/23
Next page
39
13.2. Range checking
The range check makes a really important contribution to the operational security
and safety of your model. We have developed a test procedure based on our own
experience and measurements, which will always keep you on the safe side.
§ Collapse the transmitter aerial completely, and hold the transmitter as if
operating a model.
§ The check must be carried out with the motor running.
Ask a friend to hold the model, or pack it up so that the steering and driven
wheels are free to move.
§ There must be no large metal objects (cars, wire fences, etc.) in the vicinity.
§ There is no point in carrying out the check if there are other transmitters
switched on - even on other channels.
§ Switch on the transmitter and receiver, and check that the model responds
correctly and immediately to all control commands, without carrying out
any uncontrolled movements, when the transmitter is about 30 m from the
model.
' TIP !
Poor effective range may be due to any of the following problems:
v Inadequate suppression of electric power systems and ignition systems.
v Aerial wire damaged, too short (less than 40 cm) or poorly installed.
v Environmental effects (damp ground, shielding by metal fences, etc.).
If radio range with the aerial collapsed is not sufficient, and you are unable to identify
any of the potential problems stated above, repeat the check with the aerial
extended. The safe operating distance between transmitter and model should now
be around 1.5 times the actual required radius of action.
!!
If you have any doubts, don’t run your model! Check everything again in peace
and quiet, so that you can locate and eliminate the problem reliably!
13.3. Care of the transmitter
Protect your transmitter from mechanical damage, temperatures above 60°C (direct
sunshine in a car), damp, solvents, fuel, exhaust residues and dust. Bear in mind that
condensation may occur inside the transmitter if it is subjected to a swift change of
temperature (e.g. when taken from a warm workshop to a cold car). Condensation
may prevent the transmitter working properly or at all. If this should happen, allow
the transmitter plenty of time to adjust to the new temperature, and be sure to carry
out a particularly thorough range test. Check that the transmitter is completely dry,
including the interior (battery compartment), before you switch it on.
Cleaning the transmitter
The best method of removing dust is to use a soft paintbrush. The case can be
cleaned with a slightly damp cloth and a mild household cleaning agent.
!!
Take great care that no liquids get inside the transmitter.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Multiplex PROFIcar301 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Multiplex PROFIcar301 in the language / languages: English as an attachment in your email.

The manual is 0,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Multiplex PROFIcar301

Multiplex PROFIcar301 User Manual - German - 23 pages

Multiplex PROFIcar301 User Manual - French - 23 pages

Multiplex PROFIcar301 User Manual - Spanish - 23 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info