467082
45
Zoom out
Zoom in
Previous page
1/48
Next page
45
11. Installing the receiving system in the model
Fig. VI shows the optimum arrangement of the receiving system components in the
model. As far as possible you should consider and work out the position of the re-
ceiving system components in the model even before you start building.
The following points are particularly important:
Keep the receiver as far away as possible from
- electric motors
- electrical ignition systems
- servos
- batteries
- cables (especially leads carrying high currents).
Deploy the receiver aerial in as straight a line as possible, and run it out of the
model by the most direct route
(e.g. tension it to the fin with a rubber band).
Do not shorten/extend the aerial, and don’t leave it coiled up inside the model.
Do not deploy the aerial inside a model component, or stick it on top of a
model component, which is reinforced with carbon fibre (signal shielding).
Protect the receiver from vibration. Pack it in foam and stow it loosely in the
model.
If your model has an electric power system, we recommend that you install the
receiving system as shown in Fig. VI. Keep the distance between the receiving sys-
tem and the power system as great as possible, as the currents are high and can
produce serious interference. Ensure that all electric motors are effectively sup-
pressed.
Before the first flight carry out a particularly thorough range check (see 12.2.:
range testing) with the motor stopped and with the motor running.
If you are obliged to fit servo extension leads in the model
, the long cables will
have an effect on the reception conditions inside the airframe. If the length of any
servo lead is greater than 60 cm, a separation filter must be used at the receiver.
Separation filters may also be required to eliminate interference where servo leads
run parallel to each other over a distance of 25 cm or more. Your local model shop
or the MULTIPLEX Service Dept. will provide information on what you need (see
12.5.: What should I do if I have queries or problems?)
12. The system in use
12.1. Post Office regulations for the U.K.
Radio controlled models are of two types - those which operate on the ground or
on water, known as „surface“ models, and those which operate in the air. The first
group includes model cars, trucks and buggies, and also model boats of all types.
The second encompasses fixed-wing model aircraft and rotary-wing machines
(mainly helicopters).
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Multiplex Cockpit MM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Multiplex Cockpit MM in the language / languages: English as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Multiplex Cockpit MM

Multiplex Cockpit MM User Manual - German - 48 pages

Multiplex Cockpit MM User Manual - French - 48 pages

Multiplex Cockpit MM User Manual - Italian - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info