629127

MTD SMART 46 PO Manual

11
Zoom out
Zoom in
Previous page
1/16
Next page
English Operating instructions – Lawnmower with IC engine
8
Filling with petrol and
checking oil level
Fill up with lead-free petrol
(see engine manual).
Fill fuel tank up to max. 2 cm
below the lower edge of the inlet
nozzle.
Close fuel tank tightly.
Check oil level and, if required,
top up (see Engine manual).
Starting the engine
Fig. 5
a~åÖÉê
qç=éêÉîÉåí=áåàìêóW
Ó Çç=åçí=ëí~êí=íÜÉ=ÉåÖáåÉ=ïÜÉå=óçì=
~êÉ=ëí~åÇáåÖ=áå=Ñêçåí=çÑ=íÜÉ=ÉàÉÅíçêX
Ó âÉÉé=Ü~åÇë=~åÇ=ÑÉÉí=ïÉää=~ï~ó=
Ñêçã=íÜÉ=ÅìííáåÖ=Ää~ÇÉX
Ó åÉîÉê=éä~ÅÉ=óçìê=Ü~åÇëI=ÑÉÉíI=
çê çíÜÉê=é~êíë=çÑ=íÜÉ=ÄçÇó=åÉ~ê=
êçí~íáåÖ=é~êíëX=~äï~óë=âÉÉé=~ï~ó=
Ñêçã=íÜÉ=ÉàÉÅíçêK
_ÉÑçêÉ=ëí~êíáåÖ=íÜÉ=ÉåÖáåÉI=ÇáëJ
ÉåÖ~ÖÉ=íÜÉ=ÅäìíÅÜÉë=Ñçê=~ää=ÅìííÉêë=
~åÇ=ÇêáîÉëK
aç=åçí=íáé=íÜÉ=~ééäá~åÅÉ=ïÜÉå=ëí~êJ
íáåÖK=hÉÉé=íÜÉ=~ééäá~åÅÉ=çå=~å=ÉîÉå=
ëìêÑ~ÅÉ=ïáíÜ=äáííäÉ=çê=íÜÉ=ëÜçêíÉëí=
éçëëáÄäÉ=Öê~ëëK
Information about the engine
Observe the information in the
engine manual.
– Some models do not have an
throttle. The engine speed is set
automatically. The engine always
runs at the optimal engine speed.
– Even if the engine is warm,
it may be necessary to actuate
the choke or the primer.
– Some models have no choke and
no primer. The engine is automati-
cally set to the particular starting
process.
If the engine is cold:
Open the fuel tap (if fitted).
Appliances with choke :
Set the choke lever to ,
or pull out the choke and
set the accelerator lever
(if fitted) to /max. (Fig. 5A)
or
set the accelerator lever
to (Fig. 5A).
Units with primer:
Press primer forcefully 1–5x and
move throttle (if fitted) to /max. –
Fig. 5B.
If the engine is warm:
Open the fuel tap (if fitted).
Set throttle (if available)
to /max. – Fig. 5B.
Appliances without electric
starter:
Fig. 5C
Stand behind lawnmower –
Press and hold safety hoop.
Slowly pull the starter cable grip
until you feel resistance, and then
pull quickly and strongly.
Do not let the starter cable grip
snap back, but let it return slowly.
For appliances with electric
starter:
Fig. 5D
Disconnect charger from power
supply and unit.
Stand behind lawnmower – Press
and hold safety hoop.
Turn ignition key on the steering
handle until the engine starts (start
attempt max. 5 seconds, wait at
least 1 minute before the next
attempt).
Note
If units feature electric starter,
the engine (depending on model)
can also be started manually with
the pull-starter handle.
When the engine is running:
After starting the engine (depen-
ding on the model):
– return the choke (if fitted),
– move the accelerator lever
(if fitted) between /max. and
/min. so that the engine can
warm up briefly.
Set the throttle to full throttle
(if available).
Note
If you need more information about
operating the engine, please refer
to the engine manual.
Stopping the engine
Fig. 7
Bring throttle (if available) into
position /min.
Release the safety hoop.
The engine and the cutting tool
stop after a short time.
Working with the unit
Engaging/disengaging
gear drive
(only in the case of lawnmowers with
gear drives)
Fig. 6A, B, C
Putting gear drive into gear
/:
Pull and hold the lever/hoop.
Throwing gear drive out of gear
/:
Release lever/hoop.
Information for units
according to Fig. 6C
The unit can be switched on/off
with the left or the right lever
or even with both levers together.
Note
When the unit is pulled back, the
back wheels may lock or there may
be increased resistance on account
of the design. This is not a fault with
the unit but occurs for technical
reasons.
Remedial action (depending on
model): Without pulling the drive
handle, push unit forwards a little,
then backwards.
Changing drive speed
of the wheel drive
(depending on model)
`~ìíáçå
a~ã~ÖÉ=íç=íÜÉ=ä~ïåãçïÉê
j~âÉ=~ÇàìëíãÉåíë=ïÜÉå=íÜÉ=ÉåÖáåÉ=
áë=êìååáåÖ=çåäóK
!
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MTD SMART 46 PO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MTD SMART 46 PO in the language / languages: English as an attachment in your email.

The manual is 2,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of MTD SMART 46 PO

MTD SMART 46 PO User Manual - German - 16 pages

MTD SMART 46 PO User Manual - Dutch - 16 pages

MTD SMART 46 PO User Manual - French - 17 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info