629109
12
Zoom out
Zoom in
Previous page
1/13
Next page
English Operating manual – Lawn mower with electric motor
8
Transporting the
appliance
!
Danger
Before transporting the unit on or in
a vehicle: Sw
itch off motor and
remove connection cable.
Leave motor to cool down
(approx. 30 minutes).
For transport on or in a vehicle,
secure
the ap
pliance adequately
against slipping.
Before lifting or ca
rryi
ng the unit,
pull out the mains plug. Before
moving the unit over surfaces, such
as footpaths or driveways, stop the
motor.
Caution
Do not wedge or kink the cable
which
runs between the motor and
switch/plug combination.
Figure 6
The steering handle can be
folded down to facilitate storage.
Servicing/cleaning
!
Danger
To protect against injury before all
work on the appliance
switch OFF the engine,
wait until all rotating parts have
come
to a standstill,
pull out the mains plug,
leave motor to cool down (approx.
3
0 minutes).
Servicing
!
Danger
To protect against injury from the
cutters, have
a specialist garage
perform all work such as replacing
or regrinding the cutters (special
tools required).
Before each operation
Check connection cable.
Check that threaded connections
are tight.
Check safety devices.
Check unit see section “Before
working with the unit”.
Check the point of contact of the
clut
ch:
(only in the case of lawn mowers
with ge
ar drives)
The lawn mower should not drive
forwards when the engine is run-
ning and when the gear drive is not
engaged.
The lawn mower should drive
fo
rward
s when the engine is
running and the gear drive is
engaged.
If necessary, adjust the point of
connection using the knurling
tool/adjusting nut on the gear
drive lever or Bowden cable.
Once a season
Lubricate the joints and torsion
spring on the discharge flap.
At the end of the season the
appliance must be checked and
serviced at a specialist garage.
Cleaning
Caution
Do not splash the unit with water,
otherwise electric components
may be damaged.
Clean the appliance after every
use.
Failure to clean the appliance
can damage the materials and
cause malfunctions.
Cleaning the grass sack
The easiest time to clean the grass
catcher is immediately after
mowing.
Detach and empty the grass
sack.
The grass sack can be cleaned
by means of a powerful jet of
water from a garden hose.
Allow the grass sack to dry out
thoroughly before using it again.
Cleaning lawnmower
!
Danger
Work on the cutters can cause injury.
Wear safety gloves for your
protection.
Whenever possible, always clean
the appliance directly after mowing.
Tilt the unit to the side,
clean the cutter chamber and the
ejector cover with brush, hand
broom, or cloth,
set the appliance down on its
wheels, and remove all visible
grass residue and other soiling.
Laying up the vehicle
Caution
Damage to mower materials
Keep the vehicle only in clean and
dry rooms
when the engine is cold.
During prolonged storage, e.g. in
winter, ensure that the unit is
protected against rust.
At the end of the sea
son or when
the vehicle will not be used for
longer than a month,
Clean the appliance and the
grass sack.
To protect metal parts from rust,
wipe them all down with an oiled
cloth (resin-free oil) or apply an
oil spray.
Warranty
The warranty rules issued by our
company or the importer apply to
every country. As part of the
warranty, we remedy malfunctions
on your appliance free of charge
provided that this malfunction is
caused by a material or
manufacturing defect. In the event of
a
wa
rranty claim, please turn to your
dealer or the nearest branch office.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MTD Optima 3816 E HW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MTD Optima 3816 E HW in the language / languages: English as an attachment in your email.

The manual is 1,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of MTD Optima 3816 E HW

MTD Optima 3816 E HW User Manual - German - 13 pages

MTD Optima 3816 E HW User Manual - Dutch - 13 pages

MTD Optima 3816 E HW User Manual - French - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info