547297
21
Zoom out
Zoom in
Previous page
1/38
Next page
Mount the sleeve by inserting the sleeve into the opening of the dashboard
and bend open the tabs located around the sleeve with a screwdriver. Not all
tabs will be able to make contact, so examine which ones will be most effective.
Bending open the appropriate tabs behind the dashboard to secure the sleeve
in place.
(1) Dashboard (2) Tabs
Reconnect the wire harness and the antenna and be careful not to pinch any
wires or cables.
Slide the unit into the sleeve until it locks into place.
To further secure the unit, use the supplied metal strap to secure the back of the
unit in place. Use the supplied hardware (Hex Nut (M5mm) and Spring Washer)
to attach one end of the strap to the mounting bolt on the back of the unit. If
necessary, bend the metal strap to fit your vehicle’s mounting area. Then use the
supplied hardware (Tapping Screw and Plain Washer) to attach the other end of
metal strap to a solid metal part of the vehicle under the dashboard. This strap
also helps ensure proper electrical grounding of the unit.
Note to install the short threading terminal of the mounting bolt to the back of
the unit and the other long threading terminal to the dashboard.
(1) Metal Strap; (2) Mounting Bolt;
(3) Hex Nut; (4) Spring Washer;
(5) Tapping Screw (5x25mm); (6) Plain Washer
Reconnect the cable to the vehicle battery’s negative (-) terminal. Then replace
the outer trim ring and install the unit’s front panel (see the steps of “to install
the front panel”).
Removing the unit
Make sure the ignition is turned off, then disconnect the cable from the vehicle
battery’s negative (-) terminal.
Remove the metal strap attached the back of the unit (if attached).
Press the release button to remove the front panel.
Lift the top of the outer trim ring then pull it out to remove it.
Insert both of the supplied keys into the slots at the middle left and right sides of
the unit, then pull the unit out of the dashboard.
EN
Instruction Manual
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MT Logic RD-3058MT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MT Logic RD-3058MT in the language / languages: English, Dutch as an attachment in your email.

The manual is 2,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info