646505
5
Zoom out
Zoom in
Previous page
1/22
Next page
SETTING THE CLOCK AND DELAY BREW TIME
To Set the Clock:
1. Plug the power cord into a standard
electrical outlet. The clock will flash on
the control panel to indicate that the
time has not been set yet.
2. Press and hold the HOUR and
MINUTE buttons until you reach the
current time. The AM or PM indicator
will light at the bottom of the display
(Figures 1 and 2).
The clock is now set!
NOTE: Pressing any button before setting
the clock will cause the clock to start
keeping time from 6:00 a.m. You must set
the clock if you want to use the Delay
Brew feature.
To Set the Delay Brew Time:
While the display is in the clock mode,
simply press the SET DELAY button
(Figure 3) and, while the DELAY BREW
time is flashing, set the brew time by
pressing the HOUR and MINUTE buttons.
The AM or PM indicator will light at the
bottom of the clock display. (Figure 4)
Within a few seconds the display will
change to the current time.
The Delay Brew Time is now set!
NOTE: To activate the DELAY BREW
cycle, see the Brewing Coffee Later
section.
To check the programmed time, push the
SET DELAY button. The display will show
the time you have programmed the coffee
to brew. If you press the SET DELAY
button again or wait a few seconds, the
display will switch back.
9
8
Delay Brew Would you like to wake up to a fresh pot of coffee? The timer
allows you to preset when you would like the coffeemaker to automatically begin
brewing your coffee, up to 24 hours in advance.
Special Cleaning Cycle – Enables you to easily maintain and clean mineral
deposits from your coffeemaker.
NOTE: If you have selected any of the operating functions, the coffeemaker will act upon
the last operation selected if the power is restored within 10 seconds after a power outage.
CLEAN YOUR COFFEEMAKER BEFORE USING THE FIRST TIME
Make sure your first cup of coffee is as good as can be by cleaning your MR. COFFEE
®
Coffeemaker before its first use. Just follow these simple steps:
1. Wash the decanter, decanter lid and the filter basket in a mixture of mild detergent and
water. Rinse each thoroughly (please refer to the parts diagram listed above).
2. Replace all the parts and close the lid. Then, run a brew cycle with water only, without
adding coffee and coffee filter.
3. When brewing is complete, turn your coffeemaker off, discard the water in the decanter
and rinse the decanter, decanter lid, and filter basket.
Your coffeemaker is now ready to use. Enjoy it!
F
IGURE
1
F
IGURE
2
F
IGURE
3
F
IGURE
4
EJ SERIES IB-FINAL:Layout 2 10/13/2009 12:06 AM Page 8
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mr Coffee BVMC-EJX33 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mr Coffee BVMC-EJX33 in the language / languages: English, Spanish as an attachment in your email.

The manual is 2,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info