493954
2
Zoom out
Zoom in
Previous page
1/4
Next page
6
5
4
7
BATTERY INSTALLATION
Open the battery compartment by sliding it out
and then up. (the battery compartment
is designed to stay attached so it cannot
be lost).
.
NOTE:When replacing the batteries,the recorded messages will be saved,but the date
and time will have to be reset.
NOTE:When replacing the batteries,the recorded messages will be saved,but the date
and time will have to be reset.
SETTING THE TIME AND DATE SETTING THE TIME AND DATE
When the batteries are inserted,0 hour and 0 min and Jan01 will appear in the display.Set When the batteries are inserted,0 hour and 0 min and Jan01 will appear in the display.Set
the time and date as follows: the time and date as follows:
2
REV FWD
PLAY/STOP
REC/
STOP
ERASE/REPEAT
1
3
1
2
REV FWD
PLAY/STOP
REC/
STOP
ERASE/REPEAT
TO TURN THE UNIT ON & OFF TO SWITCH BETWEEN MODES
POWER SOURCE
OPERATION
(
CONTINUED
)
1 2
1 2
RECORDING QUALITY
You can choose between there voice recording quality modes. For best sound quality,
select HP(High play);for very good sound quality, select MP(Medium Play);for longer
recording time (reasonable sound quality),select LP(long Play).
SELECTING A FILE FOLDER
This unit has four memory storage areas(file folders)to choose from, labelled A,B,C and D.
You can store 99 messages in each individual file folder, for four file folder you can totally
save 396pcs of messages.
RECORDING SENSITIVITY HOLD SWITCH
Insert two 2pcs of”AAA”size batteries.(not
Included.)
following the polarity diagram.
3
Slide the battery compartment
back in place.
R
Y BATTERY INDICATORS:
The batteries are fresh.
The batteries are weak or dead,replace.
B
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together(e.g.Alkaline and Carbon-zinc)or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged;they can overheat and rupture.(Follow battery
manufacturer’s directions.)
OPERATION
1 2
Press the PLAY/STOP button
1
to confirm
and the year will blink. Set the year using the
REV
2
and FWD
3
buttons, then press the
PLAY/STOP button
1
again to confirm.
While the date/time appears in the display,
press the
FILE/TIME button
1
to shift
between 12 or 24 time display.
Press and hold the Mode/Pause button
2
for two seconds, then release, ’SET’ will
appear in the display. Press the
Mode/Pause button
2
once again to enter
the Date /Time set mode.
3
1
2
REV FWD
PLAY/STOP
REC/
STOP
ERASE/REPEAT
Set the Month using the REV
2
and FWD
3
buttons, then press the
PLAY/STOP button
1
again to confirm.
Repeat this step to set the Day, Hour and
Minute.
3
To turn the unit on, Press the
REC/STOP
or PLAY/STOP
2
button. To
turn the unit off, simply do not touch any
button for 30 seconds, and the unit will
automatically turn off and show the time.
To enter the standby mode, press the
REC/STOP button
or PLAY/STOP
button
2
while in the Time mode. The unit will
change to the Time mode if no button is
pressed in 30 seconds. To enter the Time
mode, press the MODE/PAUSE button
3
.while in the standby mode.
1
Press and hold the MODE/PAUSE button
1
for two seconds; “SET” will appear and
the recording quality will blink press the
REV
2
or FWD
3
button to select the
desired recording quality.
When the desired recording quality appears,
press the MODE/PAUSE button twice to
confirm and return to the Time
mode or it will change to the Time mode if no
button is pressed in 30 seconds.
High Play:..................................... 878 min.
Medium Play:............................... 1759 min .
Long Play:.....................................3369 min .
OPERATION
(
CONTINUED
)
1
Press the REC/STOP
1
or PLAY/STOP
2
button to enter the standby mode. Press the
FILE/TIME button
3
to select the desired
file folder (A,B,C,D). The number at the top
right of the display indicates the total
messages recorded. The number at the
bottom of the display will indicate the total
time recorded for the selected message.
NOTE:
Each time you record a message, The unit will
assign a number, counting up 1 from the last
message number, which will be shown on the
display.
If the unit is full, FULL will appear in the
display. Delete messages in this case.
1 2
Slide the MIC SENS switch to the
LOW position if recording sounds that are
close. Select the HIGH position if recording
sounds that are further away.
Slide the HOLD switch to the LOC
K
position
to disable the buttons; HOLD will appear in
the display. Slide the HOLD switch to the OFF
Position to enable the buttons again.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mpman ICR110 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mpman ICR110 in the language / languages: English as an attachment in your email.

The manual is 0,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Mpman ICR110

Mpman ICR110 User Manual - German - 4 pages

Mpman ICR110 User Manual - Dutch - 4 pages

Mpman ICR110 User Manual - French - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info