15
USAGE AND PRACTICAL TIPS
- Prepare the biscuit dough (you will obtain the best results with slightly soft dough).
- Choose the shape by aligning the arrow and the desired shape.
- Turn the speed selector (a2) to the 2 position to start.
- Keep feeding dough through until you have obtained the desired number of biscuits.
10f : Kebbe accessory (depending on the model)
This accessory fits on the metal mincer head (ma), enabling you to make small meatballs.
, kebbe balls a type of Lebanese meat ball. The outside is usually a bulgur wheat mixture on its
own or minced bulgur wheat and meat together. The inside is often filled with vegetables or
minced meat. The cooked bulgur wheat paste is squeezed out into a hollow tube shape using
the Kebbe accessory and cut into lengths about 8 cm (3"). One end of the tube is squeezed
tightly to seal it, some minced meat or vegetable filling placed inside each tube and sealed, the
balls are then fried in hot oil.
ACCESSORIES USED
- Kebbe accessory (p), gear block assembly (l) and metal mincer head (ma).
ASSEMBLING THE ACCESSORIES
- Insert the screw (m2) into the body (m1) of the metal mincer head (ma).
- Fit the kebbe making end (p2) on the head, aligning the two lock pins with the two notches on
the metal mincer head.
- Fit the ring (p1) on the kebbe making end (p2), followed by the nut (m5) and tighten well.
- Fit the assembled head on the gear block assembly (l).
- Turn the speed selector (a2) to the 2 position to start.
For easier use, if the food gets stuck in the mincer head (m), first unlock the motor block
assembly (l) then, but not from the motor unit (a), and remove the mincer head (m).
10g : Juice and coulis accessory (depending on the model)
This accessory fits on the metal mincer head (ma), enabling you to make juice from apples,
pears, oranges etc., as well as coulis of red berries (such as strawberries, raspberries), tomatoes,
etc.
ACCESSORIES USED
- Juice and coulis accessory (q), gear block assembly (l) and metal mincer head (ma).
ASSEMBLING THE ACCESSORIES
- Insert the screw (q2) equipped with its sealing gasket (q1) into the body (m1) of the metal
mincer head (ma).
- Install the desired filter (q3) for your preparation:
q3-1: small-hole filter for juices.
q3-2: mixed-hole filter for coulis.
- Slide the nut (m5) along the filter and screw it into the mincer head (m1).
Position the juice guide (q4) under the installed filter (q3).
- Place the assembled head on the gear block assembly (l).
- Turn the speed selector (a2) to the 2 position to start.
USAGE AND PRACTICAL TIPS
- Juice: use the filter (q3-1) with a single filtration hole diameter.
- Coulis: use the filter (q3-2) with 2 filtration hole diameters for better extraction.
- Place a container under the juice guide (q4) to collect the juice and another at the end of the
filter (q3) to collect waste.
CLEANING
The filters (q3) can be cleaned easily with the brush provided (q5).
Comment: this
accessory is used
without screens
or blades.
Comment: this
accessory is used
without screens
or blades.
