4902

Moulinex Ocealys 300 A BA5 Manual

10
Zoom out
Zoom in
Previous page
1/46
Next page
12
. “ AUTO CLEAN ” (every 3 months)
In order to reduce scale build-up, Moulinex
has equipped your iron with a self-cleaning
system which we recommend is used regularly.
Follow these steps:
- Take the iron, cold and unplugged
- Set the steam control (D) to position.
- Fill the water tank of the equivalent of one
measuring beaker, set the thermostat control
(J) to MAX. Plug in the iron. As soon as the
temperature control indicator light (H) goes
out, unplug the iron and above a sink, turn
the steam control (D) to auto-clean position,
let the water tank empty completely. The
water / steam mixture will take away the
scale residue from the soleplate.
- After 2 minutes, reset the steam control (D)
to position.
- Slowly and carefully, tilt the iron from left to
right to rinse the soleplate well and to remove
any water remaining in the soleplate.
- Plug the iron in again to dry the soleplate,
do this above a cloth.
- When you have done this, unplug the iron
again.
- Drain the collector (according to model).
- Clean the soleplate with a thick, clean, damp
cotton cloth before putting the iron away or
using again (when iron is cold).
Storage
After each use:
- Empty the water tank.
- Set the steam control (D) to position.
- Leave the iron to cool.
- Wind the mains lead into a loop of around
10cm.
- Store the iron vertically on its base.
Problem Cause Solution
Iron will not heat up Bad connection Check the plug
connection
Thermostat control Adjust thermostat
(J) on Minimum control (J)
No steam, iron is Steam control (D) in Set to required
hot position sector
Water tank empty Fill the water
tank
Temperature con- Set thermostat (J)
trol too low for to appropriate
‘aqua-stop’ model steam section,
according to the
fabric being ironed
Water dripping Iron being used in Wait until tempe-
from holes on steam mode befo- rature control indi-
soleplate when re indicator light cator light (H) goes
iron is used (H) has gone out. out for the first time
before iron in steam
mode
Steam output Lower output with
too high steam control (D)
Spray or shot of Water tank empty Refill water tank
steam does not
work
Reduction in steam Scale beginning to Carry out ‘auto
output build up clean’ function
Water tank almost Fill water tank
empty
Iron causes brown Water used contains Carry out the ‘Auto
marks on clothes organic products Clean’ operation
and change water.
See “recommended
water types”
Water dripping from Iron stored flat with Set steam control
holes of soleplate water in the water (D) to position,
when iron is stored tank empty and store
vertically on its base
If you have followed all the instructions
and your iron still does not work, consult a
Moulinex approved service centre (see list in
Moulinex Service Booklet)
Ironing Guide
. WHICH TEMPERATURE TO USE
Look at the labels on your clothes to find out
the composition of the material or the ironing
instructions.
Ironing Fabric Type Thermostat
Instructions
Synthetic Fibres:
acrylic, polyamide, polyester
Artificial Fibres: •
Viscose
Natural fibres (1): ••
wool, silk
Natural Fibres (2): •••
Cotton
Thick cotton, linen Maxi
Attention: Do not iron this item of clothing
. If the fabric is made up of different types of
textile, set the control to the lowest
recommended temperature. If you cannot
find the composition of the fabric on the la-
9
10
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Moulinex Ocealys 300 A BA5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Moulinex Ocealys 300 A BA5 in the language / languages: Dutch as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info