4898

Moulinex Ocealys 150 A BA2 Manual

9
Zoom out
Zoom in
Previous page
1/46
Next page
11
Attention: Moulinex will not be held
responsible for any use which is inappropriate
or which does not conform to the safety
guidelines.
Usage Recommendations
. USING THE APPLIANCE
- Check that the steam control (D) is in po-
sition.
- Plug the iron in.
- Control the temperature with the thermostat
control (J). The temperature control indicator
light (H) will come on. It will go out when the
soleplate has reached the required
temperature.
When using the appliance for the first time, a
little smoke may be given off. This will pass,
and does not affect the quality of your iron.
. FILLING THE WATER TANK (large capacity
300cm
3
)
- Always unplug the appliance before filling
the water tank.
- Set the steam control (D) to position.
- Fill the water tank via the refill hole (C)
situated at the front of the iron.
- Do not exceed the maximum fill level (L).
. STEAM IRONING
According to the model, the steam output of
your iron will vary between 5 to 20g or 25g per
minute
- Select the steam output by setting the steam
control (D) to the required sector.
Notes
- Steam ironing is only possible within the
range indicated on the thermostat control (J)
. DRY IRONING
- Set the steam control (D) to position.
. SPRAY
- Press button (F) in short bursts. The spraying
of water allows the dampening of fabric when
in dry or in steam position. This is very ef-
fective for smoothing out a crease.
. SHOT OF STEAM
- Press the steam shot button (E). Your iron
will let out an immediate powerful jet of
steam.
Note:
- Do not do more than 5 successive short
bursts, this will prevent the iron from dripping.
- Always use this function within the range
indicated on the thermostat control (J)
- When using steam shot for the first time,
small deposits of scale may be thrown out
along with the steam, through the soleplate.
We therefore recommend not to use the first
jets of steam, in short bursts, on fabrics.
. VERTICAL PRESS (according to model)
It is possible to use the iron in vertical position
to press clothes on hangers, curtains etc.
- Set the thermostat control (J) to MAXI posi-
tion.
- Hold the iron in vertical position near to the
material without touching it. Press the button
(E) at the rate of one short burst per second
maximum. The produced steam is not
always visible, but still retains its pressing
power.
Note: You can do up to 5 short bursts when
the iron is in vertical position. Return the iron
to horizontal position for a few seconds and
then resume vertical pressing.
Important:
- It is not recommended that vertical press is
used on synthetic fibres.
- Always keep a distance between the iron and
the material to avoid burning.
- As the produced steam is always very hot,
never press clothes when being worn by
somebody. Always use clothes on a hanger.
. “ AQUA-STOP ” (anti-drip) (according to
model)
This system permanently controls the
temperature of the soleplate. Below a certain
temperature, the ‘Aqua-stop’ system cuts off
the water flow, preventing it from dripping on
to clothes.
Maintenance
. SCALE COLLECTOR DEVICE (I) (according to
model)
- Remove the scale collector device (I)
regularly in order to remove scale deposits
which have built up inside it.
- Carry out this operation before each use or
when the soleplate is cold.
- With one hand, hold the iron by the handle
(pointed end upwards)
- With the other hand, gently pull the collector
with an upward and downward movement
until it comes away from its housing.
- Empty the contents
- Replace the collector.
Note: The hardness of the water used will
determine how often you need to carry out this
procedure. We recommend every 3 months
after each ‘auto-clean’.
2
3
4
5
6
7
8
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Moulinex Ocealys 150 A BA2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Moulinex Ocealys 150 A BA2 in the language / languages: Dutch as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info