4890

Moulinex Atoll 100 A ER1 Manual

8
Zoom out
Zoom in
Previous page
1/50
Next page
12
Please note: Steam ironing is only possible in
the steam zone indicated on the temperature
adjustment control (J).
. DRY IRONING
- Adjust the steam adjustment control (C) to
the setting
.
. SPRAY
- Press the spray button (E) in pulses. A spray
of cold water enables you to dampen your
laundry whether you are ironing dry or with
steam. Very effective in getting rid of a
crease!
. PRESSING (depending on model)
- Push the pressing button (F). Your iron will
then instantly release a high-powered jet of
steam.
Notes:
- Do not exceed 5 successive pulses, in order
to prevent your iron from dripping.
- Always use this function in the steam zone
indicated on the temperature adjustment
control (J).
- When you use the pressing function for the
first time, small fragments of scale may come
out of with the jet of steam via the holes in
the soleplate. We therefore advise that you
do not make the first presses directly above
your laundry.
. PERFECTPOINT (depending on model)
- Press button (G). Your iron will instantly
release a high-powered jet of steam,
concentrated on the zone in front of the
soleplate, for reaching difficult places
(armholes, buttonholes, etc.).
. VERTICAL CREASE REMOVAL (depending on
model)
You also have the option of using your iron in
the vertical position to remove creases from
your clothes on a hanger, curtains, etc.
For models without the Perfectpoint
system:
- Set the temperature adjustment control (J)
to «MAX» setting.
- Hold the iron in the vertical position close to
the fabric, without touching it. Push the
pressing button (F) at the rate of not more
than one pulse per second.
For models with the Perfectpoint system:
- Set the temperature adjustment control (J)
to «MAX» setting.
- Hold the iron in the vertical position close to
the fabric, without touching it. Press the
Perfectpoint button (G)
at the rate of not
more than one pulse per second.
Notes:
- You can use up to 5 pulses in the vertical
position. Put down your iron for a few
seconds before resuming crease removal.
- The steam produced is not always visible,
but still retains its ability to remove creases.
Important: Never use this function for synthetic
fibres. Keep the iron far away enough from the
fabric to avoid any risk of scorching. As the
steam produced is very hot, never remove
creases from a garment which is being worn
by someone - it must always be on a hanger.
. “AQUA STOP” (drip-stop system)
(depending on model)
This system controls the temperature of the
soleplate at all times. Below a certain
temperature, the “Aqua Stop” system cuts off
the flow of water and stops the iron from
dripping onto the laundry.
. ANTICALC SYSTEM (anti-scale system)
(depending on model)
This fixed system, located within the tank,
reduces the problems linked with scale build-
up.
To prolong the effectiveness of this system,
we advise that you perform the following
operation approximately once every 30 uses:
The iron is cold and unplugged.
- Completely dissolve 1 tablespoon of salt
(NaCl - cooking salt) in 1/2 litre of cold water.
- Fill the tank with this mixture and leave it to
act for 15 minutes.
- Empty the tank.
- Repeat the same operation with the
remaining mixture.
- Then fill the tank with fresh water to rinse
and empty it.
Maintenance
. AUTO-CLEANING
In order to reduce the formation of scale,
Moulinex has integrated an auto-cleaning
system into your iron, which we advise you to
operate at regular intervals. Please follow
these steps:
- The iron should be cold and unplugged.
- Set the steam adjustment control (C) to
position
.
- Fill the tank up to the maximum level.
5
6
7
8
Fers ATOLL.Eu11 17/10/00, 16:2212
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Moulinex Atoll 100 A ER1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Moulinex Atoll 100 A ER1 in the language / languages: Dutch as an attachment in your email.

The manual is 0,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info