779611
16
Zoom out
Zoom in
Previous page
1/16
Next page
The coaxial cable’s ground shield is intended to be connected to the building’s
Earth ground. Attachment to earth ground is typically provided through your
cable service provider's installation.
Marking information is located on the bottom of the MM1025.
Recycling - This product bears the selective sorting symbol for Waste electrical
and electronic equipment (WEEE). This means that in the EU, this
product must be handled pursuant to European directive 2012/19/EU in
order to be recycled or dismantled to minimize its impact on the
environment. User has the choice to give his product to a competent
recycling organization or to the retailer when he buys a new electrical or
electronic equipment.
Label Symbols
SYMBOL
INDICATES
DC voltage
AC voltage
For indoor use only
Class II equipment
Energy Efficiency Marking
LPS Limited Power Source supply
Center-positive DC power input connector polarity
FCC Statement
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment. This device complies with Class B Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Note: this equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruations, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures: reorient
or relocate the receiving antenna, increase the separation between the equipment and receiver, connect the
equipment into an outlet on a circuit different from that to which the receiver is connected, and/or consult the
dealer or an experienced radio/TV technician for help.
Produced by MTRLC LLC, official licensee for this product. PO Box 121147 Boston, MA 02112-1147
©Motorola Mobility LLC 2020. MOTOROLA, the Stylized Motorola Logo, and the Stylized M Logo are trademarks
or registered trademarks of Motorola Trademark Holdings, LLC. and are used under license. All other trademarks
are the property of their respective owners. All rights reserved.
27795-EL-A/1470
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Motorola MM1025 - MoCA Adapter at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Motorola MM1025 - MoCA Adapter in the language / languages: English as an attachment in your email.

The manual is 5.64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info