779580

Motorola ML1100 Manual

12
Zoom out
Zoom in
Previous page
1/35
Next page
12
7 Connections and Setup
7.1 Important Installation Information
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the jack is specifically designed for
wet locations.
• Never touch uninsulated telephone wires or terminals unless the telephone line is
disconnected from the network.
• Use caution when installing or modifying telephone lines.
• Temporarily disconnect any other equipment connected to the telephone.
7.2 Important Installation Guidelines
• Install telephone near both a telephone jack and an electrical power outlet.
• Avoid sources of noise, such as a window or a busy street, and electrical noise, such as
motors, microwave ovens and fluorescent lighting.
• Avoid heat sources, such as heating air ducts, heating appliances, radiators and
direct sunlight.
• Avoid areas of excessive moisture or extremely low temperature.
• Avoid dusty locations.
• Avoid other cordless telephones or personal computers.
CAUTION
Always disconnect all phone cords from the base unit before battery installation
or replacement.
NOTE
Certain other communications devices may also use the DECT 6.0 frequency for
communication, and, if not properly set, these devices may interfere with each other and/or
your new telephone. If you are concerned with interference, please refer to the owner’s manual
for these devices on how to properly set channels to avoid interference.
7.3 Installing the Phone
The Motorola ML1000 may be connected to either two 2-line (RJ14C) wall jacks or four single
line (RJ11C) wall jacks to accommodate all four lines. The Motorola ML1100 does not require
connection to telephone lines.
Choose an area near an electrical outlet and telephone wall jack. Your phone should be placed
on a level surface, such as a table top or desk.
Install 5 AAA-size alkaline batteries (not included) for backup power in the event of a power
failure. To open the battery door, find the tab on the top of the battery compartment. Push
down on the tab and pull away from the phone. A flat bladed screw driver may be needed.
Insert the batteries only as shown on the diagram inside the battery compartment.
NOTE
If the low battery appears in the display, you will need to replace the batteries to ensure unit
operation during a power failure.
IMPORTANT
If you are not going to use the telephone for more than 30 days, remove the batteries to avoid
battery leakage and damage to the unit.
Plug the AC power supply cord into the power jack on the back of the base and the other end
into an electrical outlet.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Motorola ML1100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Motorola ML1100 in the language / languages: English as an attachment in your email.

The manual is 1.44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info