610704
18
Zoom out
Zoom in
Previous page
1/31
Next page
18 Using the phone
NOTE
If pulse mode is selected, press TONE/* to switch from pulse to tone dialing
temporarily when dialing out. After the call is ended, the dial mode will
change back to pulse.
3.16 Setting the flash time
The default flash time is
600MS
. It is unlikely that you should need to change
this setting unless advised to do so.
1.
Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP BS
.
2.
Press MENU and then VOL+ or REDIAL/VOL- to select
FLASH TIME
.
3.
Press MENU and then VOL+ or REDIAL/VOL- to the flash time you
want. (8 options are available:
90
,
100
,
110
,
250
,
300
,
400
,
600
and
700MS
)
4.
Press MENU to save.
3.17 Setting the area code
1.
Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP BS
.
2.
Press MENU and then VOL+ or REDIAL/VOL- to select
AREA CODE
.
3.
Press MENU and enter the area code.
4.
Press MENU to save.
3.18 Registration
Up to 5 handsets can be registered to one base. The original handset is
pre-registered to use. Additional handsets must be registered to the base
before you can use them.
To register an additional handset,
1.
Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP HS
.
2.
Press MENU and then VOL+ or REDIAL/VOL- to select
REGISTRATION
.
3.
Press MENU and then VOL+ or REDIAL/VOL- to select
YES
or
NO
.
4.
Select
YES
and press MENU to enter the registration procedure as
below:
1.
Press and hold FIND for 4 seconds on base, and then release.
2.
Place the unregistered cordless handset on the charger.
3.
A confirmation tone is generated if registration is successful.
HANDSET X
is displayed where
X
denotes the number of handsets and
the phone goes back to idle.
To register an originally unregistered handset, follow steps 1 through 3
above.
3.19 To reset all settings
1.
Press MENU and VOL+ or REDIAL/VOL- to select
RESET SETTINGS
.
2.
Press MENU and VOL+ or REDIAL/VOL- to select
ALL SETTINGS
.
3.
Press MENU to select
YES
. Then all the personalized settings will be
reset to default.
NOTE
All of your phonebook entries, calls list and redial list will remain
unchanged.
3.20 Paging/Find handset
Press FIND on the base. All handsets registered to the base will ring.
To stop the paging, press FIND again, or press any key on the handset, or
place the handset on the base.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Motorola H201 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Motorola H201 in the language / languages: English as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Motorola H201

Motorola H201 Quick start guide - English, French, Spanish - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info