551116
13
Zoom out
Zoom in
Previous page
1/157
Next page
STRUCTURE
Sect. 1 - GENERAL INFORMATION
MGS corsa user's manual - page 1-7
DANGER
Never reuse a circlip or snap ring. These parts must always be renewed once they have been
disturbed.
When fitting a new circlip or snap ring, take care to move the open ends apart just enough to allow
fitting to the shaft.
Make it a rule to check that a newly-fitted circlip or snap ring has located fully into its groove.
Never clean a bearing with compressed air.
CAUTION All bearings must rotate freely with no hard spots or noise. Replace any bearings that do not meet these
requirements.
- Use ORIGINAL Moto Guzzi spare parts only.
- Use the specified lubricants and consumables.
- Where possible, lubricate a part before assembly.
- When tightening nuts and bolts, start with the largest or innermost nut/bolt and observe a cross pattern. Tighten
evenly, in subsequent steps until achieving the specified torque.
- Replace any self-locking nuts, gaskets, seals, circlips or snap rings, O-rings, split pins, bolts and screws which
have a damaged thread.
- Lubricate the bearings abundantly before assembly.
- Make it a rule to check that all components you have fitted are correctly in place.
- After repairing the motorcycle and after each service inspection, perform the preliminary checks, and then
operate the motorcycle in a private estate area or in a safe area away from traffic.
- Clean all mating surfaces, oil seal edges and gaskets before assembly. Apply a thin layer of lithium grease along
the edges of oil seals. Fit oil seals and bearings with the marking or serial number facing outwards (in view).
ELECTRICAL CONNECTORS
To disconnect the electrical connectors, follow the procedures below. Failure to comply with these procedures may
lead to irreparable damage to the connector and the wiring as well.
If present, press the special safety hooks.
WARNING
Do not pull cables to disconnect the two connectors.
Grasp the two connectors and disconnect them by pulling them in the two opposite directions.
In case of dirt, rust, moisture, etc.., thoroughly clean the inside of the connectors with compressed air.
Make sure that the cables are correctly fitted inside the connector terminals.
CAUTION The two connectors have just one correct positioning. Make sure to position them in the right direction.
Then fit the two connectors. Make sure they are correctly coupled (a click will be heard if hooks are present).
TIGHTENING TORQUE SETTINGS
DANGER
Always remember that the tightening torque settings of all wheel, brake, wheel shaft and other
suspension parts play a fundamental role to ensure vehicle safety. Make sure that these values are
always within the specified limits.
Check fastening parts tightening torque settings at regular intervals. Upon reassembly, always use a
torque wrench.
Failure to comply with these recommendations could lead to the loosening and detachment of one of
these parts with a consequent locking of the wheel or other serious troubles affecting the vehicle
manoeuvrability, and thus the risk of falls and serious injuries or death.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Moto Guzzi MGS Corsa at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Moto Guzzi MGS Corsa in the language / languages: English as an attachment in your email.

The manual is 8,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info