32 Chapter 2 Using your C5v/F5v Setting display options
Tablet only
The “tablet only” display theme uses the tablet display only.
Connect an external monitor
To connect an external monitor to the C5v/F5v, you use the CFT-Series docking station, sold
separately.
To set up an external monitor
1. Connect the monitor cable from the external monitor into the CFT-Series docking station
according to the CFT-Series Docking Station User’s Guide.
2. Plug in the external monitor and turn it on.
3. If necessary, install software and drivers for the monitor. See the manufacturer’s
documentation for more information.
4. Open
Motion Dashboard.
5. Tap Display.
6. Select a Display Scheme.
7. If your tablet PC does not respond to touch, follow the steps below to enable touch on
the correct display.
Resetting touch after adding other monitors
After setting up an external monitor, touch might be disabled on your tablet because
Windows 7 assumes that the external display is for touch input. You can enable touch on
the correct display from the Motion Dashboard by following the procedure below. You’ll
need a keyboard.
To enable touch when your tablet is connected to an external display
1. If it isn’t already, attach a keyboard to the tablet.
2. Open Motion Dashboard.
3. Tap Pen & Tablet.
4. Tap Tablet PC Settings.
5. Select the Display tab.
6. Tap Setup next to “Configure your pen and touch displays.”
7. Tap Touch Input.
8. Press the Enter key until you see the instructions appear on the display that you want to
use for touch input.
9. Follow the on-screen instructions.
10.Press Esc to end the process.