Manual Morso S80-90 (page 33 of 40) (English, Danish)

744448

Zoom out

Zoom in

1/40

2.1 Lighting instructions and fuelling intervals

A lot of air is needed when lighting the stove. If you are starting with a cold stove, the door

should be left ajar for the rst few minutes. In order to build up an insulating layer of ash in

the bottom of the stove, you should burn 3 kg of dry kindling when you light the stove the

rst time.

Always keep approx. 1 cm ash in the bottom of the combustion chamber.

1. A layer of embers will form rapidly if the stove is lit with 2-4 fuel tablets or 7-10 rolled-up

sheets of newspaper underneath approx. 3-4 kg dry kindling.

2. Open up completely for the secondary air supply by means of the regulation lever.

3. After the paper/solid alcohol tablets have caught re, leave the re door ajar about 2 cm

so that the chimney draws well.

4. When you can see that the chimney is hot enough to draw (after 5-10 minutes), close the

door. If all the necessary conditions are met, a thick layer of embers will have been formed

in the combustion chamber after another 15-20 minutes.

5. Re-stoking should normally be carried out while embers still remain. Distribute the em-

bers in the bottom, ensuring that most of them are at the front of the stove.

6. Place 2-4 logs of rewood, each weighing approximately 0.7-1 kg and 30-60 cm long, over

the embers in one layer separated by approximately 1 cm. The best combustion is obtained if

the longitudinal dimension of the logs is parallel with the rear wall of the stove.

7. When the secondary air supply is opened to maximum and the door is closed, the new

quantity of wood will ignite in a few minutes.

8. Subsequently, the secondary air supply is adjusted to the desired level, and the optimum

combustion will continue until only embers are left.

Make sure that there is always enough air (oxygen) to maintain clear, lasting ames when,

and after, reducing the amount of combustion air.

Under the nominal test, the rell interval was 60-70 minutes.

9. A new portion of wood can be added by repeating steps 5 & 6.

Important!

It is important that the fresh quantity of wood starts to burn quickly. To ensure the

fuel lights quickly, open the combustion air to max. or leave the door ajar to allow in the

amount of air needed to light the wood.

If, however, the wood only smoulders, there will be a strong build-up of smoke, which

at worst can cause an explosive ignition of the ue gases with the risk of material

damage and personal injury.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Morso S80-90 in the language / languages: English, Danish as an attachment in your email.

The manual is 0,91 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Morso S80-90 Manual

Product: