Manual Morso S50-40 (page 26 of 36) (English, Danish)

744523

Zoom out

Zoom in

1/36

DK ENG

2.0 Firing/using the stove

Your stove is constructed with air inlets in two places.

Pre-heated, fast-moving combustion air is added to the ﬁre above the glass window, and is reg-

ulated using the handle above the door. The combustion air is let in when the handle is pushed

to the right, and shut off when the handle is pushed to the left.

Another air inlet provides constant, pre-heated air supply which cannot be adjusted, and which

comes into the combustion chamber just above the ﬁre. This helps burn off the last few gasses

emitted by the wood while it is being heated.

The stove’s rated heat output is 8,0 kW.

Your new Morsø stove is EN-tested for ﬁring with wood, and is suitable for intermittent use.

NB!

Wood is a material that contains a great deal of gas (approx. 75%). The gases are released

when the wood is lit and heated. For this reason, it is important that these gases are ignited

quickly after stoking. If the wood just lies smouldering, especially after re-stoking, a lot of

smoke is created which, in the worst case, may cause an explosive ignition of the gases, re-

sulting in damage to the stove.

In order to ignite the gases that are released from the wood, and to keep clear, lasting ﬂa-

mes during the combustion process, it is important to let in the required quantity of oxygen

(air supply) at all times. The setting of the air supply, the method of ignition and the lighting

intervals depend on the draught in the chimney, the wind and weather, the amount of heat

required, the fuel, etc. This means that it may take some time before you get to know the

correct functioning of the stove under any given circumstances.

Although you can ﬁre your Morsø stove with almost all kinds of wood, you should not ﬁre

with wet wood, or unseasoned wood. Wood ought to be stored under a roof for at least 1

year, and preferably 2 years, with free access to wind. Wood should be chopped as soon as

possible after felling if it is to dry quickly. The wood can be used once the moisture is less

than 20%. During the EN test, all stoves are tested with wood with a moisture content of (16

± 4)%.

Never use driftwood as it usually has a high salt content, which damages both the stove and

the chimney. Impregnated and painted wood and chipboard emit poisonous smoke and fu-

mes so they should not be used as fuel either

Please note that liquid fuel may not be used in the stove.

Pieces of wood with a diameter exceeding 10 cm should always be chopped.

The pieces of wood should be short enough to be able to lie ﬂat over the layers of embers,

with air at both ends. The maximum length of fuel in the stove is 30 cm. The maximum qu-

antity of fuel is approx. 2 kg/hour (max. 2 pieces of wood each time you re-stoke).

The ﬁrst few times you light the stove, the ﬁre should be moderate so that the heat-resi-

stant paint can harden before ﬁring more vigorously. During the hardening phase, the paint

may develop obnoxious smoke and smell the ﬁrst time it is lit, which is very normal. Make

sure that the room is well ventilated during this period.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Morso S50-40 in the language / languages: English, Danish as an attachment in your email.

The manual is 0,78 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Morso S50-40 Manual

Product: