15
Sprog
5. Fuel - Wood
•Permitted fuel
Dry, well-stored untreated wood (preferably hardwood), wood briquettes.
•Clean combustion
The wood must be dry (relative moisture content < 15%) and untreated. In addition,
the correct amount of wood must be burnt to achieve clean combustion with low emis-
sions.
•Damp wood produces a low heat value and the surfaces inside the replace inset will
quickly become sooted over. A light layer of soot after 2-3 times of use is however nor-
mal.
•The guarantee is no longer valid if the incorrect fuel is used!
6. Special instructions
• Please note that the surfaces of the replace inset can become very hot during use.
We recommend wearing protective gloves when operating the replace insert. Please
make children aware of the dangers and keep them away from the replace inset when
in use.
• To stop the replace insert from overheating, do not close the air grates when stoking.
• A maximum amount of wood has been calculated for each replace insert. Larger
amounts than those stated can lead to overheating, which can damage the replace in-
sert!
Maximum amount of wood:
Morsø S100-12 3.4 kg/hour
Morsø S101-11 and S101-12 3.2 kg/hour
Morsø S120-21 and S120-22 3.2 kg/hour
Morsø S121-21 1.7 kg/hour
Morsø S122-22 3.2 kg/hour
Morsø S140-41 and S140-42 1.9 kg/hour
Morsø S160-32 and S161-32 3.4 kg/hour
The second stoking should be done approx. 45 min. after the replace insert is rst l-
led. Adding additional fuel is therefore often not necessary. However, if you want to sto-
ke the re more, extend the time between lling and reduce the amount of wood (0.5 – 1
kg).
