812186

Morso Forno Spin Manual

114
Zoom out
Zoom in
Previous page
1/136
Next page
114
LEGGERE QUESTA SEZIONE PRIMA DELL'USO
Controllo delle perdite di gas
Prima del primo utilizzo e ogni volta che si ricarica la bombola di gas e la si ricollega, è importante vericare
l'assenza di perdite di gas.
Svolgimento del controllo delle perdite
• Controllare che tutte le manopole di controllo siano chiuse (posizione OFF).
• In un piccolo contenitore, miscelare acqua e detergente/sapone.
• Mescolare bene la soluzione per ottenere acqua saponata.
• Aprire il regolatore della bombola di gas.
• Con una spazzola o un nebulizzatore, applicare la soluzione saponata alla linea del gas e a ciascun collega-
mento nella linea del gas, tra cui:
- Il raccordo del gas all'ingresso del dispositivo
- Tutti i raccordi dei tubi del gas
- Il raccordo del gas sulla bombola
• Eventuali bolle indicano la presenza di una perdita di gas.
• Se la perdita è sul raccordo, stringere e sigillare nuovamente.
• Se la perdita è altrove o se non è possibile eliminarla perdita il raccordo, NON UTILIZZARE IL PRODOTTO.
• Sostituire il tubo del gas e il regolatore.
• I tubi e i regolatori di ricambio si possono acquistare presso un rivenditore specializzato in prodotti idraulici.
READ ME FIRST
Gas leak testing
It is important that you leak test the BBQ before rst use and every time the gas cylinder is relled and
reconnected to the BBQ.
To Complete Leak Test
• Make sure all the control knobs are OFF.
• In a small container, mix up a solution of water and detergent/soap.
• Mix the solution well (about the same concentrate as washing up water).
• Turn the cylinder ON by rotating the knob to open position.
• Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line including:
- the gas connection at the inlet of the BBQ
- all gas hose connections
- the gas connection at the gas cylinder
• If bubbles appear, there is a gas leak.
• If the leak is at the connection, re-tighten and re-seal.
• If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NOT PROCEED.
• Replace gas hose and regulator.
• Replace hose and regulators can be purchased from your local BBQ retail specialist.
READ ME FIRST
Gas leak testing
It is important that you leak test the BBQ before rst use and every time the gas cylinder is relled and
reconnected to the BBQ.
To Complete Leak Test
• Make sure all the control knobs are OFF.
• In a small container, mix up a solution of water and detergent/soap.
• Mix the solution well (about the same concentrate as washing up water).
• Turn the cylinder ON by rotating the knob to open position.
• Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line including:
- the gas connection at the inlet of the BBQ
- all gas hose connections
- the gas connection at the gas cylinder
• If bubbles appear, there is a gas leak.
• If the leak is at the connection, re-tighten and re-seal.
• If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NOT PROCEED.
• Replace gas hose and regulator.
• Replace hose and regulators can be purchased from your local BBQ retail specialist.
READ ME FIRST
Gas leak testing
It is important that you leak test the BBQ before rst use and every time the gas cylinder is relled and
reconnected to the BBQ.
To Complete Leak Test
• Make sure all the control knobs are OFF.
• In a small container, mix up a solution of water and detergent/soap.
• Mix the solution well (about the same concentrate as washing up water).
• Turn the cylinder ON by rotating the knob to open position.
• Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line including:
- the gas connection at the inlet of the BBQ
- all gas hose connections
- the gas connection at the gas cylinder
• If bubbles appear, there is a gas leak.
• If the leak is at the connection, re-tighten and re-seal.
• If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NOT PROCEED.
• Replace gas hose and regulator.
• Replace hose and regulators can be purchased from your local BBQ retail specialist.
READ ME FIRST
Gas leak testing
It is important that you leak test the BBQ before rst use and every time the gas cylinder is relled and
reconnected to the BBQ.
To Complete Leak Test
• Make sure all the control knobs are OFF.
• In a small container, mix up a solution of water and detergent/soap.
• Mix the solution well (about the same concentrate as washing up water).
• Turn the cylinder ON by rotating the knob to open position.
• Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line including:
- the gas connection at the inlet of the BBQ
- all gas hose connections
- the gas connection at the gas cylinder
• If bubbles appear, there is a gas leak.
• If the leak is at the connection, re-tighten and re-seal.
• If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NOT PROCEED.
• Replace gas hose and regulator.
• Replace hose and regulators can be purchased from your local BBQ retail specialist.
… 114 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Morso Forno Spin at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Morso Forno Spin in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 7.71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info