812186
30
Zoom out
Zoom in
Previous page
1/136
Next page
30
WICHTIGE HINWEISE
Gasdichtheitsprüfung
Führen Sie nach jedem Nachfüllen und Anschließen der Gasasche eine Gasdichtheitsprüfung durch.
So geht die Gasdichtheitsprüfung
Achten Sie darauf, dass alle Knöpfe aus AUS stehen.
Mischen Sie in einem kleinen Behälter eine Lösung aus Wasser und Reinigungsmittel/Seife.
Durchmischen Sie die Lösung gut (etwas ein Konzentrat wie bei Seifenwasser).
Drehen Sie den Regler an der Gasasche auf.
Geben Sie mit einer Bürste oder Sprühasche Seifenlösung auf die Gasleitung und alle Verbindungen an
der Gasleitung, darunter:
- den Gasanschluss am Einlauf zum Gerät
- alle Gasschlauchanschlüsse
- den Gasanschluss an der Gasasche
Wenn sich Bläschen bilden, gibt es ein Gasleck.
Wenn das Leck sich am Anschluss bendet, ziehen Sie diesen fest und erneuern Sie die Dichtung.
Wenn sich das Leck anderswo bendet oder Sie das Leck nicht durch Festziehen des Anschlusses be-
heben können, MACHEN SIE NICHT WEITER.
Ersetzen Sie den Gasschlauch und Regler.
Ersatzschläuche und -regler sind im Fachhandel erhältlich.
READ ME FIRST
Gas leak testing
It is important that you leak test the BBQ before rst use and every time the gas cylinder is relled and
reconnected to the BBQ.
To Complete Leak Test
Make sure all the control knobs are OFF.
In a small container, mix up a solution of water and detergent/soap.
Mix the solution well (about the same concentrate as washing up water).
Turn the cylinder ON by rotating the knob to open position.
Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line including:
- the gas connection at the inlet of the BBQ
- all gas hose connections
- the gas connection at the gas cylinder
If bubbles appear, there is a gas leak.
If the leak is at the connection, re-tighten and re-seal.
If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NOT PROCEED.
Replace gas hose and regulator.
Replace hose and regulators can be purchased from your local BBQ retail specialist.
READ ME FIRST
Gas leak testing
It is important that you leak test the BBQ before rst use and every time the gas cylinder is relled and
reconnected to the BBQ.
To Complete Leak Test
Make sure all the control knobs are OFF.
In a small container, mix up a solution of water and detergent/soap.
Mix the solution well (about the same concentrate as washing up water).
Turn the cylinder ON by rotating the knob to open position.
Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line including:
- the gas connection at the inlet of the BBQ
- all gas hose connections
- the gas connection at the gas cylinder
If bubbles appear, there is a gas leak.
If the leak is at the connection, re-tighten and re-seal.
If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NOT PROCEED.
Replace gas hose and regulator.
Replace hose and regulators can be purchased from your local BBQ retail specialist.
READ ME FIRST
Gas leak testing
It is important that you leak test the BBQ before rst use and every time the gas cylinder is relled and
reconnected to the BBQ.
To Complete Leak Test
Make sure all the control knobs are OFF.
In a small container, mix up a solution of water and detergent/soap.
Mix the solution well (about the same concentrate as washing up water).
Turn the cylinder ON by rotating the knob to open position.
Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line including:
- the gas connection at the inlet of the BBQ
- all gas hose connections
- the gas connection at the gas cylinder
If bubbles appear, there is a gas leak.
If the leak is at the connection, re-tighten and re-seal.
If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NOT PROCEED.
Replace gas hose and regulator.
Replace hose and regulators can be purchased from your local BBQ retail specialist.
READ ME FIRST
Gas leak testing
It is important that you leak test the BBQ before rst use and every time the gas cylinder is relled and
reconnected to the BBQ.
To Complete Leak Test
Make sure all the control knobs are OFF.
In a small container, mix up a solution of water and detergent/soap.
Mix the solution well (about the same concentrate as washing up water).
Turn the cylinder ON by rotating the knob to open position.
Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line including:
- the gas connection at the inlet of the BBQ
- all gas hose connections
- the gas connection at the gas cylinder
If bubbles appear, there is a gas leak.
If the leak is at the connection, re-tighten and re-seal.
If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NOT PROCEED.
Replace gas hose and regulator.
Replace hose and regulators can be purchased from your local BBQ retail specialist.
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Morso Forno Spin at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Morso Forno Spin in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 7.71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info