744506

Morso 4412 Manual

16
Zoom out
Zoom in
Previous page
1/19
Next page
30
31
DK ENG
5. Re-stoking should normally be carried out while embers
still remain. Distribute the embers in the bottom, ensuring
that most of them are at the front of the stove.
6. Place 2 pieces of wood of 1 kg each and approx. 25-35
cm long over the embers in a single layer, with a distance of
approx. 1 cm.
7. Open the air supply to maximum and close the door; the
fresh wood will then ignite within a couple of minutes.
8. Reduce the amount of combustion air to the desired po-
sition, and optimal combustion will continue until there are
glowing embers in the bed.
Make sure that there is always enough air (oxygen) to main-
tain clear, lasting ames when, and after, reducing the amount
of combustion air.
During the nominal test, the stoking interval was 60-70 min-
utes.
9. A new portion of wood can be added by repeating steps
5 & 6.
Important!
It is important that the fresh quantity of wood starts
to burn quickly. To ensure the fuel lights quickly, open
the combustion air to max. or leave the door ajar to
allow in the amount of air needed to light the wood.
If, however, the wood only smoulders, there will be a
strong build-up of smoke, which at worst can cause
an explosive ignition of the ue gases with the risk
of material damage and personal injury.
The stove door should never be opened when the stove is being red vigorously.
Refuelling on to a low re bed
If there is insucient burning material in the rebed to light a new fuel charge, excessive
smoke emission can occur. Refuelling must be carried out onto a sucient quantity of glow-
ing embers and ash that the new fuel charge will ignite in a reasonable period. If there are
too few embers in the re bed, add suitable kindling to prevent excessive smoke :
Fuel overloading
The maximum amount of fuel specied in this manual should not be exceeded, overloading
can cause excess smoke.
Operation with door left open
Operation with the door open can cause excess smoke. The appliance must not be oper-
ated with the appliance door left open except as directed in the instructions.
Once the wood has burned out, it becomes glowing charcoall. If a good layer of embers has
already formed on top of a sucient layer of ash, the stove can keep warm for a very long time
We would strongly recommend that you do not leave your stove alit at night. It
harms the environment and constitutes very poor use of the wood as the gases
in the wood do not ignite at the low temperature, but settle as soot (unburned
gases) in the chimney and stove. Extreme conditions, such as poor draught in the
chimney, large quantities of wood or wet wood, may in the worst-case scenario
cause an explosive ignition.
When ring in the summer period, when there is minimal need for heat, the combustion
will be poor. The stove provides too much heat so the combustion should be reduced.
But always remember to make sure that there are lasting ames until the wood be-
comes charcoal. If you want a weaker re, stoke up using less wood.
If you re the stove using wet wood, a lot of the fuel’s thermal energy will be spent
forcing the water out of the wood, without releasing any heat to the stove. This
incomplete combustion results in a layer of soot being left in the stove, pipe and
chimney.
Comparison between ring with wood and oil:
Type of wood (moisture content 20%) No. of cubic metres per 1000 litre oil
Oak
Beech
Ash
Sycamore
Birch
Elm
Common spruce
Silver r
7.0
7.0
7.2
7.5
8.0
8.9
10.4
10.9
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Morso 4412 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Morso 4412 in the language / languages: English, Danish as an attachment in your email.

The manual is 0,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info