744394

Morso 4300 Manual

15
Zoom out
Zoom in
Previous page
1/19
Next page
28
29
DK ENG
2.0 Firing/using the stove
Your stove is constructed with air inlet in 1 place.
Pre-heated, fast-moving combustion air is fed across the glass window and is regulated us-
ing the handle located behind the lower door. The combustion air is let in when the handle
is pushed to the right and shut o when the handle is pushed to the left.
The stove’s rated heat output is 5,0 kW.
Your new Morsø stove is EN-tested for ring with wood, and is suitable for intermittent use.
2.1 Lighting instructions and fuelling intervals
A lot of air is needed when lighting the stove. If you are starting with a cold stove, the door
should be left ajar for the rst few minutes and the combustion air supply opened to maxi-
mum.
To aid lighting your stove, a starter unit has been tted in the bottom right corner of the
stove door. To keep the door ajar when starting up, lift the small stainless steel handle while
closing the door. When you can see (after 5-10 min.) that the chimney draft is established,
close the door completely by opening it a little rst. The small stainless steel handle will
drop under its own weight and move out of the startup position. The stove door then closes
by itself.
In order to build up an insulating layer of ash in the bottom of the stove, you should burn 1-1.5
kg of dry kindling when you light the stove the rst time.
Always keep approx. 1 cm ash in the bottom of the combustion chamber.
NB!
Wood is a material that contains a great deal of gas (approx. 75%). The gases are released
when the wood is lit and heated. For this reason, it is important that these gases are ig-
nited quickly after stoking. If the wood just lies smouldering, especially after re-stoking,
a lot of smoke is created which, in the worst case, may cause an explosive ignition of the
gases, resulting in damage to the stove.
In order to ignite the gases that are released from the wood, and to keep clear, lasting
ames during the combustion process, it is important to let in the required quantity of
oxygen (air supply) at all times. The setting of the air supply, the method of ignition and
the lighting intervals depend on the draught in the chimney, the wind and weather, the
amount of heat required, the fuel, etc. This means that it may take some time before
you get to know the correct functioning of the stove under any given circumstances.
Although you can re your Morsø stove with almost all kinds of wood, you should
not re with wet wood, or unseasoned wood. Wood ought to be stored under a roof
for at least 1 year, and preferably 2 years, with free access to wind. Wood should be
chopped as soon as possible after felling if it is to dry quickly. The wood can be used
once the moisture is less than 20%. During the test, all stoves are tested with wood
with a moisture content of (16 ± 4)%.
Never use driftwood as it usually has a high salt content, which damages both
the stove and the chimney. Impregnated and painted wood and chipboard emit
poisonous smoke and fumes so they should not be used as fuel either
Please note that liquid fuel may not be used in the stove.
Pieces of wood with a diameter exceeding 10 cm should always be chopped. The pieces
of wood should be short enough to be able to lie at over the layers of embers, with air
at both ends. The maximum length of fuel in the stove is 25 cm. The maximum quantity
of fuel is approx. 2 kg/hour (max. 2 pieces of wood each time you re-stoke).
The rst few times you light the stove, the re should be moderate so that the heat-
resistant paint can harden before ring more vigorously. During the hardening phase,
the paint may develop obnoxious smoke and smell the rst time it is lit, which is very
normal. Make sure that the room is well ventilated during this period.
When heating up or cooling down, the material is exposed to major temperature
dierences that may cause the stove to give o creaking sounds.
1. The layer of embers is formed quickly when lit with 2-4
kindling tablets or similar together with approx. 1-1.5 kg of
dry kindling. Place the kindling sachets evenly under the top
layer of kindling.
2. Open the air supply as much as possible. This is done
using the handle above the door.
3. After the paper/solid alcohol tablets have caught re,
leave the re door ajar so that the chimney draws well.
Lift the small stainless steel handle in the bottom right
corner of the door while the door is closing. This keeps
the door ajar during the startup stage.
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Morso 4300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Morso 4300 in the language / languages: English, Danish as an attachment in your email.

The manual is 0,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Morso 4300

Morso 4300 Usermanual and installation guide - German - 11 pages

Morso 4300 Usermanual and installation guide - Dutch, French - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info