Manual Morso 3610 (page 8 of 16) (English)

744331

Zoom out

Zoom in

1/16

ENG

2.0 Firing the stove/Using your stove

Your stove is constructed with air supplies in three places.

One air supply leads to the combustion via a duct through 2 holes at the front of the partition.

A preheated secondary air supply leads to the combustion above the glass, and a preheated

tertiary air supply leads to the combustion through the numerous holes in the smoke plate

above the ﬁre.

The secondary and tertiary air supplies are extremely simple to regulate using the handle un-

derneath the hot ash box.

The stove is ﬁtted with a detachable handle made of stainless steel – a material that is a poor

conductor of heat. When the handle is removed, the stove is more childproof.

Morsø 3610 and 3640 are large stoves. A certain amount of expansion noise should therefore

be expected during combustion in connection with heating and cooling. The stove’s rated

heat output is 9 kW. The efﬁcieny is 73,3%. Your new Morsø stove is EN-tested and recom-

mended to be ﬁred with wood. The stove is suitable for intermittent use.

N.B!

Wood is a material that contains a great deal of gas (approximately 75 %). The gases are re-

leased when the wood is lit and heated up. For this reason, it is important that the gases are

ignited quickly after stoking.

If the wood just lies smouldering, especially after re-stoking, a lot of smoke is created, which,

in the worst case, may cause an explosive ignition of the gasses, resulting in damage to the

stove.

In order to ignite the gases that are released from the wood, and to keep clear, lasting ﬂames

during the combustion process, it is important to let in the required quantity of oxygen (air sup-

ply) at all times.

The setting of the air supply, the method of ignition and the lighting intervals depend on the

draught in the chimney, the wind and weather, the amount of heat required, the fuel, etc. This

means that it may take some time before you get to know the correct functioning of the stove

under any given circumstances.

Although you can ﬁre your Morsø stove with almost all kinds of wood, you should not ﬁre with

wet wood, or unseasoned wood. Wood ought to be stored under a roof for at least 1 year, and

preferably 2 years, with free access to wind. Wood should be chopped as soon as possible after

felling if it is to dry quickly. The wood can be used once the moisture content is less than 20%.

During the EN test, all stoves are tested with wood with a moisture content of (16 ± 4)%.

Never use driftwood, as it usually has a high salt content, which damages both the stove and

the chimney. Impregnated and painted wood and chipboard emit poisonous smoke and fumes,

so they should not be used as fuel either.

Please note that liquid fuel may not be used in the stove.

Pieces of wood with a diameter greater than 10 cm should always be chopped.

The pieces of wood should be short enough to be able to lie ﬂat over the layer of embers, with

air at both ends.

The maximum length of fuel in the stove is 58 cm.

The maximum quantity of fuel is 3-3.5 kg/hour (max. 4 pieces of wood each time you re-sto-

ke).

The ﬁrst few times you light the stove, the ﬁre should be moderate, so that the heat-resistant

paint can harden before ﬁring more vigorously. During the hardening phase, the paint may

develop obnoxious smoke and smell the ﬁrst time it is lit, which is very normal. Make sure that

the room is well ventilated during this period.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Morso 3610 in the language / languages: English as an attachment in your email.

The manual is 1,25 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Morso 3610

Morso 3610 User Manual - English - 12 pages

Morso 3610 Usermanual and installation guide - German - 20 pages

Morso 3610 Usermanual and installation guide - Dutch, French - 32 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Morso 3610 Manual

Product: