744485
6
Zoom out
Zoom in
Previous page
1/12
Next page
6
2.0 Lighting technique/using your stove2.0 Lighting technique/using your stove
2.0 Lighting technique/using your stove2.0 Lighting technique/using your stove
2.0 Lighting technique/using your stove
Your stove is built with up to three separate combustion air inlets;
A
primary airprimary air
primary airprimary air
primary air
supply where the air is passes through the grate system. This is
operated either via the left handle under the ashlip or by controlling an ‘air
spinner’ located on the stove door.
A pre-heated
secondary airsecondary air
secondary airsecondary air
secondary air
supply is also fitted for speed of combustion
‘Airwash’ and is controlled either by using the handle on the right under the
ashlip or by using the air slide control above the stove door.
A
tertiary air tertiary air
tertiary air tertiary air
tertiary air
supply is fitted to some models (3400 series) where a constant
supply of pre-heated air is introduced into the firebox via the unique baffle
system. This air supply helps to establish an even more complete combustion
process of both fuel and gases. Control of this is factory fixed and cannot be
adjusted by the user.
In most cases the stove is equipped with a detachable stainless steel handle that
ensures the handle does not get too hot. When the handle is detached, the stove
is also more childproof. In cases where the handle is fixed, the stove glove should
be used to open the door
Before you light upBefore you light up
Before you light upBefore you light up
Before you light up
The first fires from new should be low in intensity as to enable the heat-resistant
paint coating to ‘cure’ completely. During the ‘curing’ process, it is expected that
the paint coating will smoke and give-off an unpleasant, acrid smell. You will notice
a blue haze in the atmosphere also, enough to set-off any smoke alarms in the
vicinity. This is quite normal. During this period, open an outside window to en-
sure adequate ventilation.
Setting the air supply, the lighting method and the refueling intervals are depend-
ant upon chimney draught, wind, weather conditions, temperature requirements
and fuel. It can take some time before you become familiar with the stove’s opti-
mum settings under given conditions.
Even though it is possible to burn most types of solid fuel in your Morsø stove,
you should not burn wet or unseasoned wood. Wood should be stored under
cover in an airy environment for at least one year but preferably two.
Never use driftwood because as a rule it has a high salt content and therefore will
cause damage to both the stove and the chimney. Chipboard, impregnated and
painted wood emit poisonous smoke and fumes and therefore must NEVER be
used as fuel.
Logs with a diameter greater than 10 cm should always be split and should be short
enough to lie flat (side to side) over the embers within the stove’s firebox with a 25mm gap
at each end.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Morso 1430 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Morso 1430 in the language / languages: English as an attachment in your email.

The manual is 0,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info