Subwoofer Controls
1. High Level Input
If your amplification system does not have a dedicated
subwoofer line output, your subwoofer must be
connected via the high level terminals on the rear panel.
Connection should be made from the speaker terminals
on your amplification system to the High Level Input
Connections.
Note: To prevent damage to the amplifier, only connect
using line level inputs OR high level inputs.
DO NOT USE BOTH METHODS OF CONNECTION AT
THE SAME TIME
2. Power Auto/On
Switches the subwoofer (amplifier) power on or off. If
switched to auto, the subwoofer will remain in standby
mode until a signal is detected at the input. The unit will
then automatically switch itself on. It will then
automatically return to standby mode if no input signal is
present for approximately five minutes. With the switch
in the 'ON' position the unit remains permanently on. The
LED positioned on the rear panel indicates whether the
unit is on or in standby mode (red for standby and green
when on).
7
2
4
6
810
12
14
16
340W
CAUTION
FOR CONTINUED PROTECTION AGAINST
FIRE HAZARD, REPLACE ONLY
WITH T2.5AL FUSE
ATTENTION
AFIN D'ASSURER UNE PRETECTION PERMANENTE
CONTRE LES RISQUES D'INCENDIE, REMPLACER UNIQUEMENT PAR UN
FUSIBLE DE MEME TYPE T2.5AL
