646331
29
Zoom out
Zoom in
Previous page
1/36
Next page
29
SECTION 7 - ROuTINE SERvICINg INSTRuCTIONS
3
2
2
7.8
BURNER REMOVAL
4
4
1. Refer to Frame 7.3.
2. Undo the two screws and remove the sump cover.
3. Lift the manifold to clear the bottom sealing gasket and remove
manifold.
4. Removethe2frontxingscrewsandloosenthe2rear
extended nuts.
4. Lift off the burner from the combustion chamber. To facilitate
the removal angle the burner as shown.
5. Fit the new burner, replacing any damaged or deteriorating
sealing gasket.
6. Reassemble in reverse order.
7.
Check the operation of the boiler.
5
7.9
IGNITION ELECTRODE
1. Remove the burner. Refer to Frame 7.8.
2. Check dimensions are correct as in
diagram below..
3. Reassemble in reverse order.
FOR REMOVAL:
1. Unplug the ignition lead and remove the
earth lead.
2. Remove the 2 retaining screws and
remove the electrode.
3. Reassemble in reverse order replacing the
gasket if necessary.
Ignition Electrode
3mm
Straight edge
Spark Gap
3.5mm
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Morco GB30 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Morco GB30 in the language / languages: English as an attachment in your email.

The manual is 7,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Morco GB30

Morco GB30 User Manual - English - 8 pages

Morco GB30 User Manual - Dutch - 10 pages

Morco GB30 User Manual - French - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info