653302
15
Zoom out
Zoom in
Previous page
1/36
Next page
15
section 5 - installation instructions
5.5 WATER AND GAS CONNECTIONS
Ensure all boss blanking plugs are removed before making any connections.
Eachvalvemustbettedtothecorrectbossasshownindiagrambelow
Do not subject any of the isolating valves to heat as the seals may be damaged.
EnsurethatthegreenbrewasherisusedontheCHowconnection.
IMPORTANT - The gas service cock is sealed with a top hat washer - DO NOT subject to heat.
Pressure Relief Valve (PRV) - Located at the bottom right hand side of the boiler connection via a 15mm diameter stub pipe.
Use a replaceable connection to ease the replacement of the valve if required.
Ensure a safe discharge point using temperature and pressure resistant materials.
5.6 AIR / FLUE SYSTEMS
Theuesystemispartoftheapplianceandisapprovedassuch.OnlyusetheuesystemssuppliedbyMorco.
Thestandarduekit(RSF303)fortheMorcoGBrangeisa600mmasshownbelow.Thereisalsoa900mmkitavailable(RSF305).
600
Turret
60
60
100
CH FLOW
DHW OUTLET
COND. DRAIN
GAS INLET
DHW INLET
CH RETURN
PRV
Part No. RSF303
The minimum cut length is 138mm (includes 30mm into elbow)
The maximum allowable length using extensions (RSF341) is:
GB24 Series II-8m(minusanyuekitoptions)
GB30 Series II-7m(minusanyuekitoptions)
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Morco GB30 Series II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Morco GB30 Series II in the language / languages: English as an attachment in your email.

The manual is 6,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info