646346

Morco F-11E Manual

15
Zoom out
Zoom in
Previous page
1/20
Next page
15
INSTALLER
11.3- FLUE TERMINAL POSITION
The heater must be installed so that the terminal is exposed to the external air.
It is important that the position of the terminal allows free passage of air across
it at all times.
It is essential to ensure that the products of combustion discharging from the
terminal cannot re-enter the building or vehicle, through ventilators, windows, or
other sources of natural air infiltration, such as other flues etc, with the exception
of doors, but not the opening windows thereof.
The minimum acceptable dimensions from the terminal to obstructions and
ventilation openings is as follows:
Directly below an opening fixed vent or window etc ............ 300mm
Ajacent to an opening fixed vent or window etc .................. 300mm
Below gutters ................................................................... 75mm
From a vertical drain pipe ................................................. 75mm
From an internal or external corner .................................... 300mm
Where the terminal is fitted in a position to which children, the elderly, or
disabled people have access (less than 1.5m above steps, decking or ground), a
suitable terminal guard should be fitted.
In certain weather conditions the terminal may emit a plume of steam.
11.4- MINIMUM CLEARANCES
Minimum clearances of 5mm to the front and sides of the heater must be
observed. However full access from the front in the form of an opening door, must
be given to allow access to the controls and for servicing.
200mm above the top of the heater case is required for the flue assembly.
150mm is required below the heater to allow easy access to the gas isolation
cock.
11.5- VENTILATION REQUIREMENTS
The Morco F-11E is a room sealed appliance and needs no purpose provided
combustion air ventilation.
11.6- ELECTRICITY SUPPLY
A 3 amp fused three pin plug and unswitched shuttered socket outlet (both
complying with BS 1363) or a 3 amp fused double pole isolator with a contact
separation of 3mm in all poles supplying only the heater should be used.
THIS APPLIANCE MUST BE EARTHED
11.7- GAS SUPPLY
Ensure the heater is set for the gas supply intended.
Ensure the regulator is of sufficient capacity to carry the maximum heater input
plus the demand for any other appliance in the system.
… 15 …


Need help? Post your question in this forum.

Forumrules
1

Forum

morco-f-11e

Reset search

  • Bonjour,
    Mon chauffe eau morco f11e fonctionne mais ne produit pas d'eau chaude Submitted on 18-4-2023 at 20:54

    Reply Report abuse

  • Notre chauffe eau morco 11 fonctionne mais ne produit pas d eau chaude Submitted on 18-4-2023 at 20:51

    Reply Report abuse

  • Pourquoi mon chauffe eau morco f 11e ne se déclenche pas est e un problème, d électrode Submitted on 2-8-2022 at 14:27

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Morco F-11E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Morco F-11E in the language / languages: English as an attachment in your email.

The manual is 1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Morco F-11E

Morco F-11E Additional guide - English - 1 pages

Morco F-11E User Manual - Dutch - 18 pages

Morco F-11E User Manual - French - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info