646338

Morco 24CPM Manual

31
Zoom out
Zoom in
Previous page
1/37
Next page
3.
Check that the DHW filter is not blocked.
4.
Check that the flue terminal is unobstructed and that the flue system is sealed
correctly.
5.
Remove the fan and burner assembly. Inspect, and if necessary, clean the
main burner using a soft brush
or
vacuum cleaner. Do not use a wire brush or
any abrasive materials.
6.
Remove ignition and ionization electrodes. Inspect and clean as necessary
using a soft brush. If either
of
the electrodes show signs
of
damage or wear,
replace the electrode and its gasket. Measure electrode separation as below:
7.
Remove the fan and burner assembly. Inspect the inside
of
the combustion
chamber and if necessary clean the inside
of
the tubes with a soft brush. Do
not brush the insulation at the rear, check the combustion chamber insulation
panels for damage and replace
if
necessary
a.
Remove the burner injector/gas restrictor.lnspect the injector for blockage
or
damage and clean/replace as necessary.
9. Remove the condensate trap bottom cleaning nut. Drain/clean as necessary
Important
Notes:
In
order to carry out servicing or replacement
of
parts the boiler front panel and
sealing panel must be removed, care must be taken to refit and seal correctly.
After completing the servicing
or
exchange
of
gas components, always test for gas
soundness
of
any disturbed joints or test points by means
of
a tightness test
or
leak
detection fluid as appropriate.
When work is complete the boiler front panel
& sealing panel must be replaced,
ensuring a good seal is made.
31
… 31 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Morco 24CPM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Morco 24CPM in the language / languages: English as an attachment in your email.

The manual is 7,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info