646338
26
Zoom out
Zoom in
Previous page
1/37
Next page
6.
COMMISSIONING
During commissioning the appliance, the following should be checked:
1.
Gas
Supply
2.
Water
Supply
3. CH Circuit
4.
Condensate
Trap
5. Flue Connections
6. Electrical Circuit
7. Flue
gas
Analysis
IMPORTANT: Open all
doors
and
windows,
extinguish
naked lights, and
DO
NOT SMOKE
whilst
purging
the
gas
line.
Before commencing the commissioning procedure, ensure that the central heating
system and the domestic hot and cold water system have been flushed. This will
remove contamination which could block the filters fitted to the cold inlet and C.H.
return connections resulting
in
incorrect functioning
of
the boiler.
6.1
GAS
SUPPLY
The
whole
gas
installation including the
meter
(if fitted)
MUST
be purged and
tested
for
gas
soundness.
Check
the
supply
inlet pressure to the boiler is correct
for
the type
of
gas
used.
6.2
DOMESTIC
HOT
WATER
Turn on the mains cold
water
isolation valve.
Fill and
vent
the installation
by
turning on hot and cold
water
taps.
Make sure that there are no leaks
in
the installation.
6.3 CENTRAL HEATING CIRCUIT
GAS PRESSURE
TEST
PO
INT
In
order
for
the boiler to function correctly, the pressure in the central heating
circuit
must
be between 1.0 and 1.4
bar
when cold. This can be seen by
pressing the button on the control panel and reading the value on the LCD
display.
The
pressure can be increased by the use
of
the filling loop - refer to
4.6.
The
central heating circuit should be filled with a
mix
of
water
and at least
25% antifreeze/inhibitor. In environments
were
temperatures drop
below
-11 deg
Celsius this percentage should be higher, with a maximum concentration
of
40%.
The
concentration d anti freeze I inhibitor should be checked using a refracto-
meter.
26
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Morco 24CPM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Morco 24CPM in the language / languages: English as an attachment in your email.

The manual is 7,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info