2
2. TO GET READY IN FOUR STEPS
To get started with the Mobeye i110 only four steps are needed.
1. Place the SIM card in the Mobeye i110.
Make sure this SIM card is not secured by a PIN code.
2. Insert the four batteries.
3. Enter at least one phone number in the Mobeye i110.
4. Check the settings.
In this chapter these steps are explained.
2.1 STEP 1: SIM CARD
To use the Mobeye i110 a SIM card from any network is needed. On this
SIM card, the PIN code security needs to be disabled. If you have a SIM
card with PIN code, you can disable this using any mobile phone and switch
off the PIN code security. Please consult the manual for that mobile phone
for the procedure.
The SIM card needs to be inserted before the batteries. When using a
prepaid SIM card, take note of the available credit. Additionally it is wise to
set a recurrent test message in the menu so the card will be used at least
once a month.
• Open the back cover (insert a key or screwdriver
into one of the deeper holes and pull back slowly).
• Insert the SIM card in the holder. For
opening/closing, move the cover slightly.
2.2 STEP 2: INSERT THE BATTERIES
Insert the four lithium 3,0 volt batteries (CR123). When replacing the
batteries, all settings remain unchanged.
After inserting the SIM card and the batteries, the Mobeye i110 will perform
a self test taking 1 minute. During the test, the light is red. If the light is
flashing red, a problem with the SIM card is detected. A reason could be no
SIM card was placed, or the PIN code security of the SIM card was not
disabled.
Close the Mobeye i110 using the 4 screws.
