475255
8
Zoom out
Zoom in
Previous page
1/110
Next page
8 1. Basic Setup and Operation
For assistance call 1(800) 332-2119
Before You Begin
1.
Review the important safety, installation, and oper-
ating information at the beginning of this book.
2.
Choose a location for your TV.
• Allowatleastfourinchesofspaceonallsides
of the TV to help prevent overheating. Over-
heating may cause premature failure of the TV
as well as shortened lamp life.
• Avoidlocationswherelightmayreflectoffthe
screen.
• Seethestandrequirementsonpage 2.
3.
Install the batteries in the remote control.
4.
Plug the TV into an AC power outlet.
TV Tips
Turning the TV On or Off
• Point the bulb end of the remote control at the
front of the TV and press the
POWER
key.
• Press the
POWER
button on the TV control
panel.
If You Turn Off the TV by Mistake
• Press
POWER
again, within about 60 seconds,
to have the TV come back on immediately.
• IIf the
STATUS
indicator is flashing green, (about
60 seconds after you shut off power), wait a
few moments for the indicator to stop flashing
and press
POWER
to turn the TV on again.
• Controlling Sound Volume
• Press
VOL
to adjust the sound level.
• See also Controlling A/V Receiver Sound
Volume” on page 31.
Changing Channels (antenna sources)
NOTE: Perform a channel scan to enable recep-
tion of digital channels. See Setup > Channel,
page 57.
• Enter the channel number using the number
keys on the remote control and press
ENTER
.
For a two-part digital channel, such as 3-1,
press
3
CANCEL
1
to include a dash (separator).
• Press
CH
to change channels one channel at a
time.
• Press and hold
CH
to move quickly through
channels.
• Press
LAST
to return to the previously tuned
channel.
• Press
GUIDE
to display ChannelView channel
listings, highlight a channel, and press
ENTER
.
• Use the Fav (Favorites) feature to tune to up to
nine favorite channels. See page 28.
• Use the
CH
key to tune to preselected groups
of channels using ChannelView custom
channel banks. See page 29.
First-Time Power-On
1.
Press the
TV
key to
ensure that the remote
control is in
TV
mode.
TV
TV
2.
Aim the bulb end of the
remote control at the TV and
press the
POWER
key
.
Wait
for the Welcome screen.
3.
If you wish to change the
menu language to Español,
press .
4.
Press to highlight EXIT.
Press
ENTER
to clear the
menu.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi WD-82838 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi WD-82838 in the language / languages: English as an attachment in your email.

The manual is 7,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info